You probably have the trailer too deep. When I am pulling the boat out of the water, we dunk the trailer to wet the entire bunk then pull the trailer...
I need to replace the strut bushing on my boat. I measured the length of the strut and it’s 8”. I can only seem to find 4” and 4 1/2” bushings. Is it...
There is a small piece that fits over the top cap piece at the front of the trunk locker. I will have to go back and look at how I built mine but if...
Rear seat is definitely able to be removed, the "back" of the bench is usually all wood, I think I have pictures in under my username of the rebuild...
So I have a new to me SG with the Polk system. The right bow speaker is operating at 20% of the volume of the left and same for forward left speaker...
Hi, I'm new to the forum. Just bought 89 Pirat without engine and gearbox. The boat is waiting in the store for new stringers and I am finishing the...
My solution was to machine a sleeve that could be slid into the piston until it bottoms. Then, when the rod is tapped into the center of the sleeve,...
Anyone know where I could get non-skid grip tape like seadeck or gatorstep that I can put on the top of my trailer fenders, preferably Supra logo? I...
JBreezy, A tale that follows. I met George while he was still working at Master craft with Rob Shirly. I did electrical work down at the old shop on...