Activity Stream

Filter

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Filter by: Last 7 Days

Clear All

Older Activity
Yesterday, 11:28 PM

Wylietunes replied to a thread Adding two speakers to tower bar in Audio & Video

Not uncommon for unused tower speakers wire to not be connected to the amp. No need to have then live. May be bundled up under the tower base. Not...

see more

1 replies | 5 view(s)
Yesterday, 11:21 PM

adam schindler started a thread Adding two speakers to tower bar in Audio & Video

I have a sr400 2020 and added two more speakers to tower bar that match the speakers on boat already had plug in place plugged speakers in but no...

see more

1 replies | 5 view(s)
Yesterday, 10:57 PM

davebloom replied to a thread 1982 Supra Mariah leaks in General Chat

Do these boats have fins / rudders in the bottom of them or some type of protruding pieces of steel that help with the turn on the boat? The other...

see more

4 replies | 25 view(s)
Yesterday, 10:55 PM

davebloom replied to a thread 1982 Supra Mariah leaks in General Chat

Nope it’s not that. I also found a couple leaks around the engine mounts and took care of those as well. It’s definitely coming from the front part...

see more

4 replies | 25 view(s)
Yesterday, 08:50 PM

cadunkle replied to a thread Hydraulic steering? in General Chat

Check for worn parts. I replaced the rudder, port, cable, and helm on my Saltare a few years ago. With the worn parts it was hard to steer at speed...

see more

3 replies | 152 view(s)
Yesterday, 08:47 PM

cadunkle replied to a thread 1982 Supra Mariah leaks in General Chat

It could also be the rudder port, earlier models have a packing gland but a 1992 probably has o-rings. I had to remove and reseal my swim platform...

see more

4 replies | 25 view(s)
Yesterday, 08:45 PM

cadunkle replied to a thread Quieter exhaust? in General Chat

I ordered the Hardin Marine transom mount silencers (https://www.cpperformance.com/p-12598-3-straight-cut-part-time-transom-mounted-silencers.aspx)....

see more

1 replies | 89 view(s)
Yesterday, 03:29 PM

Labboy started a thread May have electrical issue in Service & Repair

Put the boat in the water for first time in two years. Mechanic had issue keeping it running. Put in new fuel pump. Ran it all morning pulling skiers...

see more

0 replies | 19 view(s)
Yesterday, 03:06 PM

Sluggo replied to a thread '03 Launch SSV Spitting/coughing after 1 hour in Service & Repair

So as it turns out, the coil really appears to be bad, but it did not completely fix the issue. I still have a cold high idle with surging and I...

see more

33 replies | 5933 view(s)
Yesterday, 10:12 AM

92Supra replied to a thread Stiff steering ? in Service & Repair

I checked the rudder while it was on the lift today. There is slop side to side and front to back so I will try to repair it at my next chance. Do...

see more

2 replies | 40 view(s)
Yesterday, 09:41 AM

MJHKnox replied to a thread SeaDek in place of Cushion engine cover in Boat Owners

Here you go . . . . one thread was started by Mike Vogan or search for Hatch. ...

see more

6 replies | 193 view(s)
Yesterday, 09:39 AM

MJHKnox replied to a thread SeaDek in place of Cushion engine cover in Boat Owners

Yes, there was a picture. Like anything else, these Search engines are not the best, they just pull up a lot of results to look through. Facebook...

see more

6 replies | 193 view(s)
Yesterday, 08:03 AM

michael hunter replied to a thread 1982 Supra Mariah leaks in General Chat

Are you sure its not the prop shaft packing? They are supposed to leak a few drops per minute to lubricate the packing.

see more

4 replies | 25 view(s)
Yesterday, 03:09 AM

davebloom started a thread 1982 Supra Mariah leaks in General Chat

I am new to boating and have a 1992 boat that seems to have a consistent slow leak in the middle of the hull. Not quite sure where to look or how to...

see more

4 replies | 25 view(s)
Yesterday, 03:06 AM

davebloom replied to a thread 1987 Supra SunSport Owner's Manual in General Chat

I have a 1992 Supra Mariah and trying to find a owners manual. Any suggestions? Also have a leak somewhere in the middle of the hull. Would the...

see more

3 replies | 101 view(s)
07-13-2020, 09:40 PM

Larry Arizona replied to a thread SL 400 Low Tower Racks 3d Printed Plug in Supra Modifications

You should sell them. Sent from my iPhone using Tapatalk

see more

4 replies | 61 view(s)
07-13-2020, 09:32 PM

Larry Arizona replied to a thread Rear Ballast not draining all the way in Service & Repair

What year boat? What pumps you got? Last time your replaced impellers? Sent from my iPhone using Tapatalk

see more

2 replies | 44 view(s)
07-13-2020, 08:54 PM

Maple Valley Supra started a thread 2014 SA450 Pickle Fork Surf Wave Help in General Chat

Hey All, I'm looking or advice from anyone who owns a SA on dialing in the surf wave. I have a 2014 with the hard tanks and also the plug in play...

see more

0 replies | 18 view(s)
07-13-2020, 07:23 PM

Brian_289 started a thread WTB Walter RV-26D gear drive in Service & Repair

Going over my salty Supra project the only thing that really worries me is the gear drive. It’s so corroded the nuts and bolt heads are crumbling. As...

see more

0 replies | 11 view(s)
07-13-2020, 04:59 PM

Turbinesurgeon replied to a thread Rear Ballast not draining all the way in Service & Repair

Mine does the same thing. I have aerator pumps and my starboard side fills faster and the pump is on a 90 fitting. The port side pump is vertical and...

see more

2 replies | 44 view(s)
07-13-2020, 10:29 AM

mback28 replied to a thread SeaDek in place of Cushion engine cover in Boat Owners

How did it turn out, did he have any pictures? I posted the same question on Facebook and no one responded. So this is what I came up with.

see more

6 replies | 193 view(s)
07-13-2020, 10:00 AM

MJHKnox replied to a thread Engine cover gas strut length in General Chat

I used 6x15 with a 6.75 stroke in my 2007 Supra.

see more

2 replies | 157 view(s)
07-13-2020, 09:54 AM

Texas_SA400 started a thread Rear Ballast not draining all the way in Service & Repair

So I've started to encounter a new issue. My rear Port side ballast wont drain all the way. Starboard side drains completely. I've noticed the Port...

see more

2 replies | 44 view(s)
07-13-2020, 09:51 AM

MJHKnox replied to a thread SeaDek in place of Cushion engine cover in Boat Owners

Somebody on Facebook did the entire middle hatch.

see more

6 replies | 193 view(s)
07-13-2020, 09:43 AM

MJHKnox replied to a thread SL 400 Low Tower Racks 3d Printed Plug in Supra Modifications

Got it. Most people assume the upper and lower are the same mounts, they are not. PTM designed different mounts, but the same mounts on the...

see more

4 replies | 61 view(s)
07-12-2020, 11:58 PM

Portmax29 replied to a thread Gopro unable to connect in Audio & Video

I was having the same issue with my black hero 8 on my 2020 sl450. I ended up calling the factory and they said the hero 8 is not yet compatible but...

see more

8 replies | 12097 view(s)
07-12-2020, 10:30 PM

jkaero replied to a thread SL 400 Low Tower Racks 3d Printed Plug in Supra Modifications

Racks are going to sit in the house unused (no upper racks either). We are using the boat mostly for surfing so the canopy holders and the...

see more

4 replies | 61 view(s)
07-12-2020, 10:15 PM

MJHKnox replied to a thread SL 400 Low Tower Racks 3d Printed Plug in Supra Modifications

Nice job. What are you doing for racks if you removed the lower ones? Did you buy a boat with upper and lower racks? Sent from my P00I using...

see more

4 replies | 61 view(s)
07-12-2020, 09:49 PM

jkaero started a thread SL 400 Low Tower Racks 3d Printed Plug in Supra Modifications

All, We just got a new SL 400 and wanted to remove the lower tower racks. We took them off easy enough but it left a nasty hole in the nice black...

see more

4 replies | 61 view(s)
07-12-2020, 03:58 PM

Brian_289 started a thread 06 launch 21v fuel pump in Service & Repair

So I bought a project of a boat. It was owned by someone on here that overheated it and replaced the heads. It was sitting for two years for sale...

see more

0 replies | 32 view(s)

More Activity

All times are GMT -4. The time now is 03:11 AM.