View Full Version : Prop packing wrench?
scotthons
04-09-2012, 12:51 PM
Does anyone know where I can get a wrench that will work for this job? I have an '06 21V. Thanks.
Any BIG cressen?? wrench will work. Needs to open up to a 1"-1/2"
scotthons
04-09-2012, 04:58 PM
Thanks Jet, but I was having a hard time with the length of the wrench. It seemed to be a very small amount of room. I did not know if there was something that would work better.
scotthons
04-13-2012, 11:18 AM
Just an fyi I ordered this wrench off of ebay. I will let you know how it works out.
1-7/8" Shaft Packing Wrench for Inboards
javascript:;
csleaver
04-18-2012, 11:24 AM
Go to the hardware store and get an adjustable wrench for sink drain nuts. They are wide, thin jawed wrenches with a short handle. They sell the same ones at west marine (for about twice as much).
Blackntan90
04-22-2012, 08:42 PM
I use an 'S' shaped adjustable wrench that is probably 100 years old! No kidding, it works great. I like the idea of the sink drain wrench.
dbpainc
04-24-2012, 11:08 AM
Does anyone know where I can get a wrench that will work for this job? I have an '06 21V. Thanks.
If there is damage to the prop has been on a while you will need to pull the prop off. This will make sure you do not damage the prop more.
http://www.westmarine.com/webapp/wcs/stores/servlet/Product2_11151_10001_108360_-1____ProductDisplayErrorView
RAM MOUNTS
3 and 4 Blade Prop Removal Kit or Tool
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.