Tranny rear main seal...

[Mlaurenza]

I have to change the rear seal in my tranny. Does anyone have a parts breakdown or some diagram for a PCM 1-1 ratio tranny??? I also need the points setting and the timing degrees...thank u...

[crystal waters]

at top right of this page in the advanced search box type in "flex plate" and you will see a lot of tranny info
about 6 posts down--Haugy has a schematic--touch base with him!

[riveredge]

I think this is likely the part you'll need: http://www.skidim.com/prodinfo.asp?number=R047185

If you give skidim a call they can help you out. While you're there you should replace the few little o-rings in that area, 2 tiny ones and one big one I think. I just did this exact job recently. You can see the o-rings, and the new blue seal. Put some oil on the seal when you install it, and polish the shaft it goes onto with some very fine sandpaper like 1000.

10378
10377