PDA

View Full Version : 90 Conbrio help needed



HtxConbrio
06-30-2012, 11:40 PM
I just bought a 90 Conbrio with 500+hours. I noticed that neither of the blowers are working. Not sure if they are getting power. I was able to locate one of them in the engine compartment. Where is the second located? Also, wwhere is a good place to buy parts for this thing? It runs great but would like to replace impeller, plugs, wires, cap, rotor... All of the parts necessary for piece of mind. Any help would be greatly appreciated.

DAFF
06-30-2012, 11:43 PM
The other should be on the port rear side just beside the fuel cell. Skidim is the best place to check for parts or sometimes your local marine store can order them or has them in stock.

HtxConbrio
07-01-2012, 08:52 PM
Does anyone know where the temperature sending unit is located on a PCM 351?

matt k
07-02-2012, 01:20 PM
right on top, driver's side. kind of next to the distributer, behind the thermostat. It's a brass thing with one wire attached to the top.

I believe you can just see it peeking out from behind the front of the coil in this picture:

http://img.photobucket.com/albums/v64/horkn/113.jpg