Smart Plate fuse location for 2010 Supra 21v

[SECBENGAL]

I was out on the water this past weekend and noticed that the Smart Plate was not going up or down and not responding even when I used the manual trim tab or Vision setting for an individual rider. When I use the manual trim tab located on the steering wheel column there is no sound or anything. I'm assuming that this may be a blown fuse, so I did manually reset the main breaker, but even after I turned back on the power the Smart Plate still didn't work. I looked through the owner's manual and did not see where the fuse is located for the Smart Plate.



Where exactly is the fuse located for the Smart Plate? Also, what else can I check on or do to fix this?



My boat is about a two hour drive to the nearest Supra dealer, so bringing it in would be a major hassle.

My boat is a 2010 Supra Launch 21v.

Thanks for any help you may be able to provide.

[Kma4444]

I will look at my 2012 242 and see where it is today and see if that helps if no-one else responds.

[SECBENGAL]

Thanks Kma, I appreciate the help.

[Jon]

There is a 10 amp wakeplate breaker under the dash. You can remove the clear plastic breaker covering labeled wakeplate and make sure it has not popped. The wakeplate is also controlled by a lenco trim tab module located under the dash. Make sure all connections at the module are good. Last thing to check is the plug at the lenco ram itself. This is located inside the boat with a 2-3' lead coming away from the tab. There should be a connector there that links the lenco ram to the harness running to the module.

[Kma4444]

Now there's a good reply!!!!!!

[SECBENGAL]

Thanks Kma!! That is indeed a very god reply.

I'm going out to the boat tomorrow to check on this. I'll let you know how it goes.

Thanks Again!!

[Swamplandkarl]

Did you ever figure this out as I am having the same issue?

[Swamplandkarl]

Did you ever figure this out as I am having the same issue?

Anyone have input on this?