PDA

View Full Version : Video of my Leds



CornRickey
05-29-2013, 07:02 PM
https://www.youtube.com/watch?v=e9tjP4FRwRQ&feature=youtube_gdata_player

kvand347
05-29-2013, 09:48 PM
Dude that's bad a$$! Looks like blue flames shooting out the back! What kind are they and how much? I'm almost afraid to ask...

CornRickey
05-29-2013, 10:04 PM
Two pairs of three Oznuim spots and three floods mounted in a aluminum square tube mounted in the openings of the platform brackets. 200 with dimmer switch. The spots are a lot brighter than in the video. They shoot out about 12 feet when not moving.

CornRickey
05-29-2013, 11:47 PM
http://i1333.photobucket.com/albums/w640/CornRickey/20130528_124635_zps65655786.jpg
http://i1333.photobucket.com/albums/w640/CornRickey/20130528_124733_zpsc885c36d.jpg
http://i1333.photobucket.com/albums/w640/CornRickey/20130528_124802_zpsc13eb673.jpg

The aluminum was a left over valance for a shower enclosure that I cut too short. I have had it in my garage for 3 years now and don't know how many times I have almost thrown it away. I had to notch out about 3/8th inch on the front side of it to make room for the middle platform bracket since the three brackets aren't in a straightline. I had to slip it into the middle one and through the far one then install the closest bracket. When screwed down the aluminum is bound in there and has no fasteners. I drilled out a hole in the middle of the drain plug and ran the wires through it to keep no holes in the back. 3M 5200 bonds the LED's to the aluminum and also seals the wire within the drain plug. All are shrinked wrap for protection. I used thermostat wire to feed power to it from a dimmer switch mounted in the drivers area. All nine lights pull less than 1 amp.

comp92
05-30-2013, 11:13 AM
looks nice!
this is second thread ive seen on this and now i really want to do this. boat will look classic by day and light up the night!
good post thanks!

Cusefan78
06-18-2013, 04:46 PM
Are all the lights blue?

CornRickey
06-18-2013, 05:49 PM
Yup all blue