2001 supra sunsport v drive trim/wake plate no working pump location

[Hall_393]

Well since my tige caught on fire I picked up a 01 sunsport v drive already has Intereated ballast system which is one reason I liked it, but I can't dial in wake cause the plate won't work. I don't hear a pump kick on when I flip the switch. So my question is where is the pump located for the hydrolic actuaters. I searches and searched and can not find a thread on this anywhere.
Any help would be greatly appreciated.

[DAFF]

follow the tube coming from the centre of the transom. There will be two 1/4" lines running to a square box with a clear lid. Have you done the basics and checked you fuses ??

[Hall_393]

Yes
Fuses are all good, it's came down to the pump not coming on maybe burnt up not sure I will look tomorrow morning and try to figure the problem out.
Thank you

[Hall_393]

I followed the lines until couldn't follow them anymore an don't find anything. Is the pump in back of motor or front.

[beat taco]

It should be on a bracket screwed to the transom. They just slide onto the bracket. Try direct power to it, mine was dead and had to be replaced.
http://img.tapatalk.com/d/13/06/27/yvy9ahuh.jpg

Blurry pic of it, big thing on left.

[Hall_393]

Guess my pump is MIA cause I dont have that I that location I'll keep searching

[Hall_393]

Well I looked again I guess at one point the pump died and they took it out and never replaced it, I found all the wire for it. So now my question where would you get this pump from.

[beat taco]

http://item.mobileweb.ebay.com/viewitem?itemId=221234152796&cmd=VIDESC


Edit: Bennett 351 power unit is what you need.

[Hall_393]

Ordered thank you