View Full Version : Supra comp 351w resistance wiring question
la_torta
08-21-2013, 02:29 PM
I'm restoring a supra comp, and at the back of the engine next to the 50 amp breaker i see a resistance, and for some reason it's not wired... where is this supposed to be wired to?
Thanks
Sent from my SGH-M919 using Tapatalk 2
michael hunter
08-21-2013, 06:20 PM
Does your boat have a electronic ignition conversion ?
la_torta
08-21-2013, 09:53 PM
Ummm i need to check that, i can check that in the distributor? If its points or electronic isn't it?
Sent from my SGH-M919 using Tapatalk 2
CornRickey
08-21-2013, 10:22 PM
yup, pop the cap and rotor off. There should be either points or electronic ignition module there. EI doesn't use a ballast resistor.
la_torta
08-29-2013, 12:06 AM
In fact is ei so i will discard the other piece, thanks for the advice!!!
Sent from my SGH-M919 using Tapatalk 2
CornRickey
08-29-2013, 12:37 AM
noproblemo
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.