Looking for wakeboard rack?

[Eric1687]

Looking to buy a wakeboard rack for my 01 ssv factory tower would also like it too fit a wake surf anyone know where I can buy these ?

[Tribal 20]

I have a pair of swivel brackets without the tines. They came off of an 07 launch. Probably not gonna help but thought I would mention it. Good luck.

[Jmlloyd]

I have a 1 pr of tynes. Holds 2 wakeboards. Never used. Came with the replacement brackets and I switched to surf tynes. Let me know.

[Eric1687]

142651426514265
Here is the pics of my tower one side has a bracket on it not sure what it's for though but looking to put a rack on one side

[Patrick56]

1-7/8" oval mount. Common to Supra, Moomba and I think Four Winns of the early 2000s. Kind of hard to find aftermarket. Your other option is to mount to the vertical "round" part of the tower. Pretty sure the round tubing is 1-5/8". I have a 2003 SSV with the Rad-a-Cage as well.

[KG's Supra24]

I have a pair of swivel brackets without the tines. They came off of an 07 launch. Probably not gonna help but thought I would mention it. Good luck.

What do you have? The three pin swivel or the single pin?

[KG's Supra24]

Monster has a universal swivel rack that I've seen good reviews on.

http://www.monstertower.com/Swivel-Wakeboard-Surfboard-Rack-p/swrs-2.5.htm

I have not used the swivel one but I have a pair of their other racks that have worked well.

[ORIF]

I am in a similar situation myself with a 2002 SSV.

The 1 5/8 diameter tubing is an unusual size of tubing for a wakeboard tower and so the choices are limited.

The best option that I found so far is Sampson Typhoon spinning board rack, but I haven't pulled the trigger yet because of the cost.

http://samsonsports.com/shop/typhoon-spinning-board-racks/

[Eric1687]

So is there a rack that will mount too that oval mount ? I like that monster rack that you had the link too but it says it fits 2 1/2" diameter towers.

[ORIF]

Pricey, but good rack @ 1 5/8 in.


http://samsonsports.com/shop/typhoon-spinning-board-racks/

[Eric1687]

Anyone have the bulet lines tower racks ? Or heard of them ?

[jlgrogean]

1-7/8" oval mount. Common to Supra, Moomba and I think Four Winns of the early 2000s. Kind of hard to find aftermarket. Your other option is to mount to the vertical "round" part of the tower. Pretty sure the round tubing is 1-5/8". I have a 2003 SSV with the Rad-a-Cage as well.

what kind of racks did you go with? I also have a '03 SSV and am not too fond of the factory racks on the rad a cage. thanks

[carlossa]

New dimension towers is the company that made the towers for all the previous mentioned models with the oval clamps. I have searched high and low for a replacement or alternate solution with no luck. I actually needed just the clamps and contacted new dimensions, but they will only sell the entire assembly with fingers. I'm just going to have to make my own.

www.newdimensiontowers.com

[barelyfloating]

I went through this process a couple of years back, and settled on this semi custom install. By far the best bang for the buck. These are quick release triple racks that can hold up to 2 surf boards and 4 wakeboards for $200. I wanted them to be mounted symmetrically (too damn OCD), so I bolted them to the rack versus using the clamp. It was easy, and very rugged. Two years running in all weather and water conditions. Nothing budges. Personally, I found the swivel rack too expensive and not necessary. No regrets.

http://www.bulletlines.com/surf-board-and-wake-board-rack-p/1011.htm

1549215493

[barelyfloating]

I went with this company and did a custom install. It's been in place for two years without a problem. I can carry 4 wakeboards and two surf boards on two racks.

www.bulletlines.com/Wakeboard-Tower-Racks-s/2.htm

15558
15559
15560