PDA

View Full Version : 2001 22SSV electrical problems



quadman
06-04-2014, 11:00 PM
I'm having some issues with my 01 SSV. When I'm on the lake in choppy water the gage cluster starts going nuts and the motor will DIE!.....
The boat will crank back up and take off and run as long as I don't go to fast on the ruff water. I have done the following.
1. Checked ground engine block (looks good no corrosion and tight)
2. Checked battery connections( good no corrosion and tight)
3. Checked Wire harness on motor. ( seemed to be lose ???? but made sure that it was seated well.)

There are some wires under the dash that are not connected and they look like they may go somewhere.
Has anyone had issues like this ?
Dose anyone know where I could get a wire diagram for this boat?

lively
06-04-2014, 11:31 PM
Don't need a wiring diagram . Get a volt meter and check continuity of all your grounds to the batt . Just run the boat in the driveway and idle it up about 2k and start shaking the wire bundles . If vibration is causing it you will be able to simulate the issue very quickly


Sent from my iPhone using Tapatalk

CornRickey
06-05-2014, 01:06 AM
Check the large round connector located under the circuit breaker on the engine. Mine was corroded and caused this

quadman
06-05-2014, 01:37 AM
Check the large round connector located under the circuit breaker on the engine. Mine was corroded and caused this

That was the harness connector that I thought was a little to lose. How tight dose the connector fit on yours? Also what did you use the get the corrosion out of the female side of the connector?

CornRickey
06-05-2014, 02:36 AM
I used electrical wash and cleaned the male end with emery cloth. One of the contacts heated up and the rubber around it bulged ppt and I trimmed it flat. I took a couple wire ties and pulled the connectors back together. Has worked for 2 seasons

quadman
06-05-2014, 02:55 PM
Thanks I will give that a shot.