View Full Version : '01 Launch Hydraulic Wake Plate
Lyonslaunch
04-10-2007, 09:50 PM
I just bouaght an '01 direct drive Launch but the hydraulic wake plate is not working. I can hear the motor but there is no movement. My guess is I need to add fluid to the hydraulic motor.
Does anyone know:
1)Where the hydraulic motor is on the direct drive?
2) Where to add fluid
3) What type of fluid to add
4) Best way to access it
Thanks
H2Oman
04-11-2007, 09:00 AM
I just bouaght an '01 direct drive Launch but the hydraulic wake plate is not working. I can hear the motor but there is no movement. My guess is I need to add fluid to the hydraulic motor.
Does anyone know:
1)Where the hydraulic motor is on the direct drive?
2) Where to add fluid
3) What type of fluid to add
4) Best way to access it
Thanks
1 it is in the rear storage compartment.
2 the fluid reservoir is on the pump.
3 not sure
4 remove the rear compartment wall at the tail of the boat.
Mine did that once - it needed fluid but I can't remember what type it was. My dealer sold me the fluid.
Good luck.
DKJBama92Mariah
04-11-2007, 02:44 PM
You should use any type of automatic transmission fluid (ATF) in the hydraulic pump.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.