View Full Version : DB alterator w/ pulley - belt alignment issues
lively
07-17-2015, 05:37 PM
ok so i bought and installed a db alternator 105 amp , but now the belt is sitting to proud outward , i looked at the pulleys old vs new and they are defiantly different sizes the new one has a smaller pulley
and the old one has a larger pulley , can i swap these out to align it better or those of you that did the upgrade did you have to shim the other pulleys ?
thAnk you !
Cusefan78
07-18-2015, 07:09 AM
With an impact gun you can swap pulleys. Keep an eye out on your volt meter. I had two of those go bad in a years time. Just bought a new one from Napa because they wouldn't warranty it for the third time a few days after the one year warranty.
lively
07-18-2015, 10:33 AM
With an impact gun you can swap pulleys. Keep an eye out on your volt meter. I had two of those go bad in a years time. Just bought a new one from Napa because they wouldn't warranty it for the third time a few days after the one year warranty.
ok ill try that just didnt know if it would change the output amperage
Cusefan78
07-18-2015, 10:52 AM
Nope. I swamped the new one I got from Napa. Just hold the fan with one hand and impact the nut off. Pretty easy
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.