Stebo166
05-25-2016, 08:11 AM
I am replacing the wood on the bottom of the motor cover,does anyone know what length rivets to use?
the ones i drilled out were sunk into the 3/4" wood with nothing sticking out into engine compartment.
I dont know if this was suppose to be like that or not. Total new thickness will be like 1"....seems like its hard to find rivets that length
the ones i drilled out were sunk into the 3/4" wood with nothing sticking out into engine compartment.
I dont know if this was suppose to be like that or not. Total new thickness will be like 1"....seems like its hard to find rivets that length