Boat cover mod

[Ryan351]

Hello everyone!
I have a boat cover that was made for non-tower applications and I'm having the slits cut/sewn in for the legs. My question is what does everyone recommend/use to join the rope after its cut to go around the tower legs and obviously reconnected?

If it was a nylon strap I'd use those plastic clips.
But I can't think of anything that would work well with rope.

Thank you for any ideas and thoughts!!

Ryan.

[CJD]

Hello everyone!
I have a boat cover that was made for non-tower applications and I'm having the slits cut/sewn in for the legs. My question is what does everyone recommend/use to join the rope after its cut to go around the tower legs and obviously reconnected?

If it was a nylon strap I'd use those plastic clips.
But I can't think of anything that would work well with rope.

Thank you for any ideas and thoughts!!

Ryan.

Switch to straps and use the strap clips.

[mikebu]

Cut the rope around each tower tie and use these to connect the rope together:

https://www.aliexpress.com/item/Stainless-Steel-Bolt-Clip-Swivel-Eye-Hook-Lead-Rope-Silver-Tone/32823935869.html

Then add horizontal zippered areas over the rope in front of the front tower leg and behind the back tower leg that cover those swivel hooks. You unzip these to clip and unclip the roap.

This is what my http://evolutioncovers.com/ does.