DIY underwater led’s

[19supra19]

Took 5 lights from “Ozium” I think it’s called. Drilled 5 holes for the lights in a piece of aluminum, the lights have a small ring around the base which Is wider than the rest. Made a bracket from aluminum and clear coated it. The swim platform has a small tab I was able to drill 4 bolts to to bolt up the bracket to. Also put some silicone along the back of each of the lights to the bracket. Pretty simple and way cheaper than buying the name brand stuff for $$$ and no hull drilling. Had it on all summer so far and still works great no issues. Pics are at lake of the Ozarks.

https://uploads.tapatalk-cdn.com/20180804/bcc5b68ac3791ad7cee7960aa3f3f41b.jpghttps://uploads.tapatalk-cdn.com/20180804/0014f40389ba83e9cc4ead8dff4ef901.jpghttps://uploads.tapatalk-cdn.com/20180804/fb68b4cb3715483ded97e5169a2a9d32.jpeghttps://uploads.tapatalk-cdn.com/20180804/29e4b67c4e7e62c8aa4d3edbc8aee26e.jpg

[Thor]

Looks nice. Good job! Where did you run the wiring harness into the boat?

[19supra19]

Looks nice. Good job! Where did you run the wiring harness into the boat?

Thanks! So when I bought the boat it had been a earmark demo boat at some point and they had some old school tiny led’s ran. It comes out the boat just under the transom remote and runs to a switch panel under the dash. So can’t really give too much detail on that as I didn’t make it and I don’t have the boat with me to check it out.