New Back Seat Brace

[critterCQB]

I've always noticed that the rear seat brace of mt '86 comp wasn't in the best of shape. So I finally did something about it. Two 12' sections of PVC plank, 30 stainless wood screws, a staple gun, 6'x1' indoor/outdoor carpeting, and 3 days of leisurely labor(after work of course). Total cost of rebuild, about $50.00 at Home Depot.

http://i49.photobucket.com/albums/f281/critterCQB/IMG_1252.jpg

http://i49.photobucket.com/albums/f281/critterCQB/IMG_1253.jpg

http://i49.photobucket.com/albums/f281/critterCQB/IMG_1254.jpg

http://i49.photobucket.com/albums/f281/critterCQB/IMG_1255.jpg

[critterCQB]

http://i49.photobucket.com/albums/f281/critterCQB/IMG_1261.jpg

http://i49.photobucket.com/albums/f281/critterCQB/Picture001.jpg

http://i49.photobucket.com/albums/f281/critterCQB/Picture002.jpg

FIN!

[critterCQB]

http://i49.photobucket.com/albums/f281/critterCQB/seat.jpg

Thought I'd post one last one up of the seat put back in. It dropped right back into place. Good thing I measured twice, turns out the floorboards are higher on the starboard side than they are on the port side. It's a shame I'm just gonna have to pull it back out this fall to do the floors.