Brucedog
09-20-2020, 02:52 PM
I have a 2006 Launch 21 with Indmar Assault 325 MPI. I was changing the cap and rotor today and found that one of the screws was over-tightened and has cracked the housing and the other screw has begun to crack the other one so I'm weighing my options. Trying to make an epoxy or JB Weld repair seems plausible but I'm inclined to get an old distributor and just use the housing. I welcome all suggestions and opinions.
Also, does anybody know what the correct distributor is for that engine?
Thanks
Bruce
Also, does anybody know what the correct distributor is for that engine?
Thanks
Bruce