Coupler bolt off Trans

[saltare inverts]

I am trying to replace rear seal on my Velvet Drive trans. I am going through procedure like Skidim says to do. I am at the position to remove the nut that holds coupler on output shaft of trans. When I turn wrench it just spins trans output shaft. I tried put it in gear but still spins. Any suggestions how to remove nut or is there a better way to replace rear seal?

[knoble]

You need to use an impact wrench. That's the only way you are going to get it off!!


:cool:

[saltare inverts]

Thanks KNOBLE took it right off. I would have never guessed it. I owe you a cold :oone!!