PDA

View Full Version : 3/4" hose clamps



Fman
09-22-2009, 10:28 PM
Anyone where to find the 3/4" hose clamps that do not screw down? The same type Supra is using to tighten there hoses onto the fittings, smooth surface that does not screw down. I put a pinhole leak in my left rear drain tube today because of the screw down hose clamp. It has a little bit of a sharp edge on it and it looks like it created the pinhole while the sac was full. I could wrap in duck tape to avoid any sharp edges but would prefer to use the Supra clamps.

Thanks.........

jclose8
09-23-2009, 08:45 AM
Anyone where to find the 3/4" hose clamps that do not screw down? The same type Supra is using to tighten there hoses onto the fittings, smooth surface that does not screw down. I put a pinhole leak in my left rear drain tube today because of the screw down hose clamp. It has a little bit of a sharp edge on it and it looks like it created the pinhole while the sac was full. I could wrap in duck tape to avoid any sharp edges but would prefer to use the Supra clamps.

Thanks.........

Here are a couple of options...

Flow-rite crimp clamp (but then you need to buy the crimping tool too) https://www.flow-rite.com/catalog/united-states/marine/parts-hardware

Another option is the "Herbie Clamp" I've used these and they work great.
http://speedyproducts.com/o/

I don't know what Supra uses...