devovino
06-17-2011, 10:53 AM
So yesterday I was able to start by temping in my bases for my rear seat. Down the road I will attempt to incorporate some ballast including this area under the seat, the hard tank will look like saddlebags, I will fab it out of aluminum, and weld it to specs. I am still in the planning phase, so any ideas will help out. I still have to finish grindind out the rest of the exterior stringers, and drop the templates another 1.5 inches. I will most likely box out the exhaust, replace the area where the cross sections were in the main stringers with new wood, there was some rot there. This should be hold for the season, until winter when I tear her down ans can replace the whole stringers. For now, I am going to just finish the frame, pop the new rear seat in, and get ready to do a shake down cruise this fathers day. Well any ideas can help, thanks, Devon