View Full Version : Carb Rebuild - Remove Gasket Material
tomelenbaas
09-10-2011, 08:54 PM
I started my carb rebuild today. What's the trick to removing residual gasket material?
cadunkle
09-10-2011, 10:00 PM
gasket scraper or razor blade for the thick stuff. For what's left I use a line sander everywhere that I can, if ensures a good flat surface. Wherever I can't get a line sander I'll use a soft wire brush on a die grinder at lower RPM. If you don't have air, sandpaper and an assortment of brushes will get it done.
rludtke
09-11-2011, 12:37 PM
Soak in acetone to soften, then scrape with razor blade.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.