You probably have the trailer too deep. When I am pulling the boat out of the water, we dunk the trailer to wet the entire bunk then pull the trailer...
There is a small piece that fits over the top cap piece at the front of the trunk locker. I will have to go back and look at how I built mine but if...
Rear seat is definitely able to be removed, the "back" of the bench is usually all wood, I think I have pictures in under my username of the rebuild...
The 2006-2007-2008 should all be around the same price range. They made that boat until 2013, but I would assume the production numbers were low b/c...
While I have zero experience nor a need for what you are embarking upon, I am always curious how others solve various problems. If anything, think of...
I doubt you will see any improvement with just a coil. I have installed HEI ignition on 3 of my Supra's . I am very pleased with the results. A good...
I own a 1983 Supra Rider known as Mischief IV that has been in family since new.
As of October 1999, will be the fourth owner in same family.
It is currently undergoing rotisserie restoration after being previously restored in 2009.
As of November 26, 2016, will be the second owner of a 2012 Supra Sunsport 242. Locally purchased with only 40 hours on the motor.
As of January 1, 2019, will be the second owner of a 1991 Comp with 801 hours. Currently undergoing a full restoration but floor and stringers are composite. Factory Demo boat that was sold from the same dealer as my Rider.
Location:
Lake Nottely, Blairsville, GA
Interests:
Classic Supras
Occupation:
Taking care of my Supras
Signature
1983 Supra Rider
1991 Supra Comp ts6m
1983 Supra Beast
2012 Supra Sunsport 242