https://uploads.tapatalk-cdn.com/202...7faec59ad2.jpg
Made it as far as I could. Now I wait on parts. I’d love to be setting this all back in the boat by next week.
Sent from my iPhone using Tapatalk
Printable View
https://uploads.tapatalk-cdn.com/202...7faec59ad2.jpg
Made it as far as I could. Now I wait on parts. I’d love to be setting this all back in the boat by next week.
Sent from my iPhone using Tapatalk
This has been really fun to watch the progress. Looks like you should have it all done well before this summer.
Sent from my iPhone using Tapatalk
Nice thread. Really cool when I looked back on your first posts and the condition.
Are you redoing the floor carpet or getting something else put in?
Just catching up...very nice job!
I’m using this fake seadeck for the flooring. I used it on a swim platform I made and I’m happy with it. If it doesn’t hold up and I have to redo it, it was cheap enough!https://uploads.tapatalk-cdn.com/202...a840e5c411.jpg
Sent from my iPhone using Tapatalk
As soon as I get these pieces for my motor mounts it can be put back in the boat. They were way too shot to reuse. I’m hoping indmar sells them without making me buy two complete mounts. The rest cleaned up and I had it all powder coated. I’d like to have it back in and hear it run before the end of February.
https://uploads.tapatalk-cdn.com/202...9b6c73a96e.jpg
Sent from my iPhone using Tapatalk
Just a quick update, indmar does sell pieces for the motor mounts if anyone runs across this issue. It was under 100 bucks for the threaded portion, rubber bushings and lock nuts.
Sent from my iPhone using Tapatalk
try ski dim
Making progress https://uploads.tapatalk-cdn.com/202...0355bc2ca2.jpg
https://uploads.tapatalk-cdn.com/202...cc4fceb5e6.jpg
https://uploads.tapatalk-cdn.com/202...88493ac5b4.jpg
Now it’s down to getting the mounts adjusted and driveshaft aligned to the output flange on the V drive. It was almost 70 here Friday and it dropped to 40 yesterday and today. The garage heater is out of oil and I’m too lazy to go get some. (Maybe not lazy, but depressed by the cold weather coming back) Maybe later this week if it warms up a little I’ll finish it. That one warm day really got me motivated to get this done!
Sent from my iPhone using Tapatalk
Oh, can anyone point me to the trans temp sensor? I snapped a wire off of mine and would like to replace it. Neutral safety switch is easy to find, but that temp sensor seems to be a unicorn. I’ll cal the dealer as a last resort. I’m a big fan or sourcing my own parts and supporting small businesses.
Sent from my iPhone using Tapatalk