So I could not get my suck gate suction cups on my buddies 242 due to mold line. Anyone using a device that works on this exact boat?
Printable View
So I could not get my suck gate suction cups on my buddies 242 due to mold line. Anyone using a device that works on this exact boat?
Check this out.... Works great.... https://forum.supraboats.com/showthr...port-242/page8
Works well on the 242. Buy the one on his boat.
Sent from my P00I using Tapatalk
No issues with mine yet. Even added an additional 1000 lbs of ballast last weekend for a total of 3800 lbs and the Inland Curl ($140 model I use) performed flawlessly. Didn't budge a bit and creates a great wake. See thread below where I talk more about it. I've learned it is easier to put on underwater so I wait until all bags are full to apply.
https://forum.supraboats.com/showthr...of-wake-shaper
Few pics with wake shaper from last weekend. Notice on first pic, the splash created by shaper on left side of pic at transom. The last pic shows water up to the rub rail. Boat was loaded with 3800 lbs ballast, full tank of gas, and 6 souls on board.
http://i740.photobucket.com/albums/x...ps0uivgoh2.jpg
http://i740.photobucket.com/albums/x...psazobspfu.jpg
http://i740.photobucket.com/albums/x...pstzdlcuv5.jpg
Cool pics.
Those should dispel any 242 hull fallacy.
Sent from my P00I using Tapatalk
Dan, any help on how that 3800lb is distributed?
I ordered a nauticurl, and the 1280lb wakemakers kit for the rear lockers.
add about 500lb of lead under the left/right seats toward the rear?
Sent from my SM-N950U using Tapatalk