Search:

If They did a so called tune up they would of had the plug wires off to check/change the plugs. Make sure that the firing order is correct as this is a easy mistake and fix.

Impellor is always the first thing to check and replace, but you mentioned that you have a strainer, make sure that the strainer oring is there as this will allow it to suck air if it is not in...

Has anybody had problems with the speedo/gps on the vision system? It says gps antenna detected acquire satelites but doesn't find any. Has anybody had to change the antenna?

If you replace this with a smaller pump it will take a lot longer to fill the ballast, the stock ballast is going to have bigger than average bilge fittings,it will have at least 1" which is what...

You have to watch some applications do not like synthetic oil as it is to slipper and can cause clutch packs with friction type discs to slip and cause premature failure. You will definitely want to...

The steering should be easy to turn, if it is tight on the trailer the cable is starting to seize or has a kink in the cable. If it gets tight under load the rudder box bushings/ rudder may be worn...

On my old 90 comp with the Pcm 351 with power plus transmision it used 20w20 engine oil. It should have a tag on the transmission.

I went down to the hardware store and got a ABS plumbing clean out drain cap 1 1/2" that worked until I could get a new cap on my old 90 comp

All marine electronics (distributors, starters, alternators, etc) are designed to prevent sparks that could cause your boat to blow up! In some areas this is less likely but where it is hot it...

Your dealer would be correct, the arrow should show you the direction of fuel flow, it may let flow thru in the other direction but it will not filter correctly and may restrict the flow depending on...

What boat do you have, timing can cause this if it is advanced, if you have points the timing is always changing as they wear. If it fires to soon before top dead center the engine firing can cause...

There isn't any point to a sinking handle, the manufacturer was to cheap to put some floatation in it. It's the grip and style of bar that you want to look at, if you have 2 identical handles one...

The tranny should be a sealed unit but, the dampner plate will have to bolt up to the input for the tranny. Depending on what is wrong in there it could take out the input which would mean tranny...

It would die for no reason, but I think with the circuit breaker it would not restart I would have to reset the breaker I thought the breaker was bad but then I found a loose connection.

The...

If the black box you are refering to is on the carb it would be the electric choke, has three screws holding it on with plates.

Have you checked the ballast resistor and power back at the circuit...

If you look at the serial number on the hull, the last couple numbers will tell you the year of the boat.

That looks like it is a permanent magnet starter they are a lot smaller than the old ones...

Just another note after reading this reply, Feathering the throttle maybe an indication of starving for fuel, The carb has a acclerator pump on it that will pump fuel each time the throttle plates...

The anti siphon valve would be in the barb fitting off of the 90 on the pickup, it is simply a ball bearing a spring and a retainer. A lot of guys take them out or replace the fitting with a standard...

You had your float bowls off and said that they were clean, so the debri is not making it to the bowls, It may be stopped at the water/fuel filter or it may be something big blocking it in the tank. ...

Being you just bought the boat, You should replace the fuel/water filter, stock was on the port side just below the front of the engine. Oil should be replaced(this shouldn't have an effect on...

When they told me to do this at fly high I was a little hesitant but it does work good as long as you heat it enough but not to much. Glad to hear you got it off.

Do you have a water strainer on the unit, if so there is a o-ring on the bowl of the strainer if this is gone or bad it can suck air in and this can also cause the temps to go up. It never hurts to...

If it is a factory bag they cement them in with pvc cement. if you heat the bag at the fitting for a minimum of 5 minutes with a blow dryer on high, not a heat gun (to hot), you but the heel of your...

I would not take the water fuel seperator out, you can drain the canister and put it back on you don't have to replace the filter each time.

If you have a lot of water in the tank it can only get...

Lead was used in gas to help prevent detonation, it also acted as a lubricant. Old muscle cars had high compression ratios and were able to do so because of the lead in the fuel, If the boat has a...