Search:

Happy Summer to all,

I have a 95 hydrodyne grand sport and it needs the carpet to be replaced, it was installed new with the top cap off. If I remove the screws from the left and right side of the...

After a quick google search, I found a service manual, and it is indeed a low pressure fuel pump feeding the high pressure fuel pump. BTW my misfire is a bad plug.

Thanks,

wow I need spell check, sorry about the grammar

Good Morning,

I have a 95 Hydrocyne with a efi 5.8 gt40 engine, while diagnosing a misfire I noticed there is what appears to be 2 fule pumps inline with each other?? the one closest to the fuel...

No to much going on in the kneeboard/waterski section so I thought i would post it here.

Do you think it will be ok to kneeboard off of the tower? it should be about the same amount of weight to...

Thanks for the removal technique, cant get any easier than that. When i do it i will take a crap load of pics for a DIY

Great idea i just emailed RTM productions who has the shows Detroit Muscle, Power Nation ect, I asked them if they had ever thought about a weekly show about water skiing, wake boarding, surfing and...

I am heading to the lake later today I will check, i was concerned it may be attached to the gear de-Select mechanism just below the knob

Seems like a silly question, but i tried to remove the throttle knob in my 1995 hydrodyne but I dont see how it comes off, the knob is and always was a tiny bit loose but it will not turn ccw to...

Wow i need to turn on spell check, i ordered a clutch plate kit, gasket and o-ring set, and service manual

Thanks for the help, i ordered a manual clutch plated and gasket/o-ring kit trough skidim, the trans is doing ok right now but i want to have the parts on hand in case it lets go on me. The rebuild...

Great thanks, anyone have a link to the rebuild procedures?

Yes i. Changed the trans fluid when i summerized it, dextron 3

So I was out playing on the water and during a hard and fast turn my transmission slipped, I thought it was cavitation but it did it again, I can still use it I just need to be a little cautious...

I like that, it is what I had in mind, it does make a nice lounge seat.

Thanks

Summer on the way,

Hey folks I have a 95 Hydrodyne Gran Sport and it has no storage for ski's, life vests ect, I want to buy (or build if I have to) a bench seat with hinged top that sits behind...

Thats not a wakeboard tower it is a trapeze for lake tricks

No Joke I thought this was going to be a pic of a hot mama puting on sun tan oil LOLOLOL

I just picked up this 95 hydrodyne, 351 GT40 FI engine, love it13034

Thanks for the responses, My coil is mounted on the left side of the air inlet of the fuel injection system, it has an electrical connector so it is not marked as neg or pos.

Fran

Anyone know what wire is the tachometer lead from the engine on a 1995 Ford GT40 EFI??

My tack is acting up, reading 2k at idle, theres no way it's at 2k its more like 800rpm's

Thanks

I am installing the safety switch because me 16 yr old is now taking the boat out with his friends, he is cautious and more that trusted with the responsibility of driving the boat, but it is a piece...

I think you need to pull off the loose paint first, the re-evaluate. It appears to be just the paint is lifting.

Howdy,

I just bought a tethered safety kill switch that completes the circuit with the lanyard installed, so when I pull the lanyard it will open the circuit. I was planning on installing this...

Correction, I meant to say remove the cotterpin and tighten the nut.