Rear sundeck mounted on top
864386448645
Type: Posts; User: oldman
Rear sundeck mounted on top
864386448645
You want the large rail on the back of boat(Not the platform rail)? Would you pay $50 plus shipping?
Bump, If no one wants these they are going to the scrapyard.
When you cut the ends of the stringers(for drainage) at the transom, cut them at a arc or round, it is much stronger than straight 90 notch.
Would like to see pics of stringer restoration.
Once you start to tab and wrap the wood stinger in you will feel the strength of the epoxy and fiberglass cloth. Enough layers of epoxy and cloth makes the doug fir just a good form for your rock...
I coat all my doug fir with cpes.
Don't forget a couple coats of cpes on the stringer, to insure a long lasting job.
lively
Don't think you have to cut the stringer perfect with one cut. You can cut a little at a time. Getting closer and closer to the proper height and fit. It's easier to scribe the closer you...
A compass like the one you draw circles with. A sharp point on one side a pencil on the other. Get with a carpenter or handyman and get a lesson!
Don't forget the angle on the bottom of stringer...
Scribe to fit.
Maybe it's just some sealant holding on. Can you twist the one plate around a couple times while you secure the other plate.
Wish I was closer so I could attend. What a great setting to share the word of God!
Ohms low 240 mid 103 full 33
Just put the standard replacement sender in a old malibu tank.
Bought from Skidim 30 bucks will fit up to a 24 inch deep tank.
Easy install and worked fine.
Marine tex works good for filling small holes.
You won't regret that choice. Remember you can't use woven roving with epoxy. Clean and wipe down all surfaces with acetone or equal before applying
epoxy. Some epoxy will amber blush, so clean...
Thanks for the info. Sybermike. I bought a 200 and it has worked great.
Water levels are all good.
I've gone with the no carpet look for this summer, but over 85 hours of riding and pushing for more!
That's my youngest son and a friend of his. They throw up some really fun tricks with a lot of funny names. We're well over 50 hours on the boat so far this season. It's all about riding behind...
I also thank you cadunkle. Sharing that info and all your info from other posts has been very helpful! Thanks again Oldman
That's what it's all about, doesn't get any better! Congrats
That's what I was thinking, because when I run it all the way down the boat is out of control and crazy spray. But I have two issue that might not let me adjust the plate. 1. If I ballast the boat...
I agree with jsandy, I run a 143 degree from skidim and my engine runs around 160 degrees give or take.
Finally had a chance to install my new horn I purchased from Walmart. The missing glass really lets the sound travel. Wake plate in the fully up and down positions. Does that look fairly normal?
...