Search:

Type: Posts; User: michael hunter

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. I said I hope it all works out for you .

    I said I hope it all works out for you .
  2. Replies
    2
    Views
    75

    Why did you replace it?

    Why did you replace it?
  3. Replies
    4
    Views
    163

    Only one I found was 172.95 from Perko. I have...

    Only one I found was 172.95 from Perko. I have been boating for 35 years and never anchored at night . All I needed was a running light. I bought a 2 pin from amazon for 17.00
  4. Replies
    4
    Views
    163

    I bought the 2 pin nav light had to remove the...

    I bought the 2 pin nav light had to remove the lower plug assb and move the left side connector on the light to the center. You will loose the anchor light capability but the running light will work...
  5. Replies
    1
    Views
    59

    If the battery's are good and the wires going the...

    If the battery's are good and the wires going the the starter are good you probably need a starter . Sometimes the local auto supply store has a machine to test the starter.
  6. Replies
    4
    Views
    163

    I am also looking for a three pin nav light for...

    I am also looking for a three pin nav light for my comp. They seem to be no longer available . I will probably just replace the whole thing with a 2 pin since we never anchor at night anyway.
  7. Where is the boat?

    Where is the boat?
  8. Try starting the engine and tapping on the MAS...

    Try starting the engine and tapping on the MAS with the back of a screwdriver. Any change in the running replace the sensor. Look carefully at the sensor GM normally puts numbers on them.
  9. What happens when you remove the return line at...

    What happens when you remove the return line at the tank and let it flow into a separate container ? Does the fuel flow unrestricted? If not remove line at the fuel rail.
  10. I have never heard of a fuel pump putting out too...

    I have never heard of a fuel pump putting out too much pressure ? It sounds like they were on the right path and then went to lala land. I would tell them if they want to try fuel pumps that's fine...
  11. Try posting pics to Imgur.com then paste them to...

    Try posting pics to Imgur.com then paste them to the forum.
  12. Buy some cheap oil and oil filters change oil and...

    Buy some cheap oil and oil filters change oil and filter run for a few minutes and change it again. It may take 3-4 times to flush the oil out . Then put your normal oil and filter and give it a try....
  13. Replies
    7
    Views
    301

    There is a comp on facebook [Supra and Moomba...

    There is a comp on facebook [Supra and Moomba owners group] in Ohio with a blown trans 800.00
  14. Check every hose connection on the suction side...

    Check every hose connection on the suction side of the raw water pump. Pull the impeller and inspect for damage [ new doesn't mean good] make sure the thermostat is working it may have been damaged...
  15. When you overheat on the water and shut down the...

    When you overheat on the water and shut down the engine it will create a vacuum in the exhaust and suck the water into the exhaust manifolds and through the open exhaust valves into the cylinders....
  16. Replies
    3
    Views
    156

    Is it just a keyed ign switch? They are available...

    Is it just a keyed ign switch? They are available everywhere . 3 wire without accessory or 4 wire with accessory mode.
  17. The reason I didn't buy a Supra in 08 was the...

    The reason I didn't buy a Supra in 08 was the seating . I told the rep at the Chicago boat show if you could build me a boat with the front walk through of a Sunsport and the rear seating of a launch...
  18. Replies
    7
    Views
    243

    There is a lot more heat under the hood of a car...

    There is a lot more heat under the hood of a car and those wires don't become brittle and short out. Can the harness be removed opened up and inspected wire by wire?
  19. Did you say you put a new fuel pump and regulator...

    Did you say you put a new fuel pump and regulator on it?
  20. Replies
    1
    Views
    125

    MAP [ manifold absolute pressure ] sensor...

    MAP [ manifold absolute pressure ] sensor measures vacuum witch is related to engine load . Check and make sure the vacuum hose has manifold vacuum and is connected to the MAP sensor. The Baro sensor...
  21. Replies
    7
    Views
    243

    What was wrong with the original harness that was...

    What was wrong with the original harness that was bad enough to require a complete replacement?
  22. Replies
    2
    Views
    113

    Either block off the exhaust pipes in the rear or...

    Either block off the exhaust pipes in the rear or disconnect the hoses going to the front of the exhaust manifolds and block the hoses. Don't put too much pressure on the block 10 to 15 lbs max.
  23. Replies
    4
    Views
    194

    Don't need spark plugs or wires yet . I change...

    Don't need spark plugs or wires yet . I change oil and filter every 50 hours . I use Mobil 1 15w50 in all my boats . The 15w50 is whats recommended by Mobil for both roller and flat lifter engines. I...
  24. Replies
    5
    Views
    332

    I always go deep with the trailers and float the...

    I always go deep with the trailers and float the boat within a foot or two of the winch. Its much easier on the boat and bunks. Sometimes you will have to back it in again to center it up . With the...
  25. Sorry to hear you are buying an Axis they started...

    Sorry to hear you are buying an Axis they started out as a entry level economy boat now they are priced right up there with the big boys .You will lose more in the first year then the selling price...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4