It is the second wave , not the first that will catch your bow, and you off guard.
As your nose goes over the first wave it dives down the first wave and meets the trough of second wave head on....
Type: Posts; User: crystal waters
It is the second wave , not the first that will catch your bow, and you off guard.
As your nose goes over the first wave it dives down the first wave and meets the trough of second wave head on....
I use dex for the trans fluid.
The chattering sounds like the flex plate in your trans needs to be replaced.
Not uncommon.
I switched out the pins a long time ago.
Now use stainless steel bolts with lock nuts
Much better
The advice you have received is spot on!
All I can add is to provide a “stop” to prevent boat going too far forward on the lift and thus preventing your prop shaft from striking bottom cross member...
For what its worth I have original pan and it has a small drain hole in one corner that allows water
to end up in bilge area.
That said I always lay an old towel in the pan simply to keep my feet...
Go to this thread
https://forum.supraboats.com/showthread.php?15453-Clockwise-vs-CCW-LH-vs-RH-Standard-vs-Reverse-Help-me-get-this-down-once-amp-for-all
Doesnt sound at all normal.
What size and make of motor?
351 ford pcm ?
That would be the drain hole from which you remove the plug and drop the oil drain line down thru in order to drain your engine oil . Assuming it is a mid engine boat.
Go to you tube
Look up “Drakes Detailing”
Lots of clips but find “ how to wash ,wax ,detail your boat.
Great info !
Have the key, the cassette and case, the three ring binder and all its contents
89 conbrio second owner since 92.19514195151951619517
Bracket(s) are part of the overall mirror . Not separate piece(s)
U shaped with tightening screw that allows one to place U shaped bracket(s) over windshield frame and
Then simply tighten down...
1950219503
On conbrio the center windshield opens but this would work even on comp.
Far prefer this to previous comp I had with dash mounted mirror
Are you looking for the glass or the plastic lever mechanism that allows you to open and close the window.
I would think a good glass shop could take a template and cut you the piece required.
If...
I would check the engine over thoroughly to see if the over heating also did some damage there.
If picture unclear pm me with your email address and I will send you clear photo
19368
Hope this helps
Go to you tube
Look up “ski boat overheating and cooling 101”
Ron Tanis
This guy is great!
Whole heartedly concur!
Skiboatcovers.com
Check your coil
If no luck, call skidim ( Skiers Discount Marine)
Go to Skiers Discount Marine
Aka SkiDim
They know it all and have it all.
Techs can assist you!
As Mischief IV said - - -
Call Skiers Discount Marine
Aka Ski Dim
They are your best source for parts - know their stuff!
They will also give you technical advice on how to change your...
Some of the older Supra models had vinyl stickers applied along the gunnel under the side of the windshield.
For example , my 89 conbrio has the wording “classic” in place referring to the model of...
Are you referring to the decal mounted on the outside of the windshield , alongside the gunnel?
Some readers may be thinking of a decal inside the boat on the dash or ?
Red in gas could well be fuel additive from previous owner to help preserve the gas although ten years goes beyond reasonable expectations.
Ski Dim is awesome! Used them a number of times in the...
Try using a smaller narrower tube to get around any obstacles although I do not believe you should run into any within the tank itself.
—- or a larger tube in case it is crud that is clogging your...