Sender is cheap. Replace in the tank. Nothing to it
Type: Posts; User: kreckley
Sender is cheap. Replace in the tank. Nothing to it
Any interested parties. Thinking of selling. Runs perfect. 3174322883. First year forfiberglass stringers and floor..no rot
Still looking. I'm thinking of selling my 92 in great condition low hrs and fiberglass stringers, floor
Ok I mean perfect seats 454, composite floor and stringers. Body shiny like a mirror and engine compartment that is very clean esp after looking at some of the pics I've seen on this site. No...
Whats my spotless 500hr boat worth with trailer
The transmission fluid should be a little more red tan what I am seeing. I would change that. Run you motor and pour 50/50 antifreeze through the intake till it comes out the exhaust and your good ...
dog out of hole can be accel pump Think toooo much fuel also Rebuild on the carb on older boats with new seats (in carb) clean any buildup off floats goes a long way Wouldn't mess with time
still selling
Best place to buy resin is Illstreet They have the resin and fiberglass mat. You want to use cotton flox to fill in the voids under the new stingers and round the transition to the floor from the...
FYI you dont need to disconnect any of the sensors or sending units with conversion. The sensors only get disabled when you convert Your gauges will work as before
1 3 and 4 are sensors to the computer 2 is water temp sender to the dash Your oil pressure sender is on the same T with the sensor. You dont have to be a mech to change this to electronic. ...
I understand the feeling of going backwards because that was the way the boat was delivered. But who says the new tech at the time the boat was built IS better than the old ttried and proven. I see...
I just put mallory marine dist in and a new coil with wires on my 92 454 and it hasn't run better. Very easy The info here comes tooooo slow You can call me if you want or I will check this...
Vince is very helpful but their kit is 2x more than it should be I converted my 92 saltare 454 for 330 including the 60 for wires and it was easy. I boat on a large lake in Ky that is not a...
Jeff DO NOT SPEND 500 TO 600 unless you love to burn cash Give me a call and I will tell you how to fix and where to order your parts I have no vested interest in any company but my own Doctor...
Excuse me if you can't understand God help you with texting
jeff I have always worked on every motor I'VE owed If your spark is intermitent Timing will not do squat for you and will just waste another weekend of fun. You need to find if it is electrical...
switches unnecessary after mallory conversion Just manage the gauges 454 runs strong
I just typed a book to you and the connection went down Lots of stuff on pcm if you still haveit Knock water and oil sensors that will put engine in limp mode. Clean eveery connection you can...
Could be the computer depending on age
you have a bent prop
any auto electrical rebuild outfit can do it. Don't blow money you don't have to Its just a motor
It takes dam little fuel pump to make the holly work I would look very carefully at the float bowls and at that altitude it may need rejecting to lean it after you figure out why its not getting gas
impeller every other year If parts are broken off .....find them
If your impeller is not drawing in enough water or your water pump is blocked or one of the lines or water jacket on your motor from an old impeller shredding IT will run the exhaust hot and usually...