Search:

Nice to see all the old paper work. Hopefully documented and saved for the future

Congrats. A decent looking boat. Have fun.

You may get faster response on Facebook. Drew Tinker seems to be a guy that works at Supra and is frequently on the Supra and Moomba Owners group.

I highly doubt Skier's Choice will have a skin, although it wouldn't hurt to ask. $350 per cushion is about the going rate where I am at. As far as the lettering, you can try...

Normally the issue is resolved by adding the low pressure fuel pump. Not sure how to test this, but I would see if you could test the low pressure fuel pump to make sure it is working.

Going...

I agree with your assessment, however one thing I would suggest looking for is whether or not you are getting vapor lock. If it always runs fine when cold then that could be your culprit. Does your...

SMP is still in the trailer business, just not boat trailer business. I have been quoted 6-7K for a new trailer for my boat. National builders like Boatmate and Ez-Loader are an option. I did see...

If we are talking raw water pumps, then most will work in either direction, just need to have the hoses in the correct orientation. Looking at a previous pic you posted, the pump will turn...

Have you checked fuel pressure also what is timing set at? Is the backfire happen all of a sudden? If it happens suddenly then it tends to be ignition however if it happens slower then it tends to...

I was going to say pics or it didn't happen ;)

1. Most likely not. Although I can imagine someone with a big enough 3d printer could make one
2. Sounds like there is an issue with the pump or there is not enough water. My cheap amazon pump has...

I have not found a depth finder that uses a 4" hole, all of them are 2". Although if you are into vintage you may be able to find an old fish finder from an 80s or earlier 90s bass boat that is 4"

For those that might have this issue somewhere down the road, I found the correct procedure to fix my issue on correctcraftfan.

1. Disconnect cables at trans and carb

2. At the morse control...

The main negative cable attaches somewhere on the engine. I have mine attached to the back of the starboard side cylinder head.

Not sure on the 1st part, the forum really shrinks down the pics....

2. When I put the motor back in the boat how can I tell how far back to put it? I assume just matching it where the exhaust hoses from the engine that meet the stainless exhaust tubes will work?
...

This forum is so slow, I don't think that you are going to find anyone to post pictures. However Bakes Online does have a picture of the letter from Indmar regarding generally where and how to...

I noticed on the last outing that the throttle delay is missing. So when you move the throttle at the helm the engine starts revving up before the transmission is fully in gear. I pulled the Morse...

What model of Supra do you have? We need to know what model to provide the length of cable.

Third time is a charm. Finally got a VIN assigned and now eligible for getting registration for the trailer. :D Just in time for an upcoming trip to a lake that actually has water. In that time...

Texas got a lot more stringent on boat and trailer registration since Hurricane Ike. There was a lot of people that were claiming abandoned and lost boats and trailers. It used to be a lot easier...

Another set back. The trailer does not have a vin that I can find anywhere on the trailer. So I went to the sheriff to start the process of getting the trailer registered as a homemade trailer. ...

I'm not sure where you might be able to find them, but I would look at the model numbers by the contacts and google those to see what comes up. Digikey maybe has them.

Congrats on the new boat. Does look like it got pulled out of forest.

In terms of restoring the gelcoat, I would first get it cleaned to get rid of the dirt and grime. Then be prepared to get an...

That sounds like a dead battery. I just replaced a battery that was outputting 12.3v but would not turn over the engine. On the flip side, I had a bad connection on my battery and was only getting...

To my knowledge the few 91's that were composite were late production runs. No way to really tell unless you pull a bolt out of the stringer. But I would imagine that if the floor is rotten that...