At this point I can't really help you very much. You could have a problem where the bank is actually lean and that is causing the catalyst to run hot or the manifold is running hot causing the o2...
Type: Posts; User: Wulphie
At this point I can't really help you very much. You could have a problem where the bank is actually lean and that is causing the catalyst to run hot or the manifold is running hot causing the o2...
It would be from reduced water flow which could be a couple of things. The first thing would be the impeller in the raw water pump. They can loose their elasticity over time and still pump water just...
I don't know much if anything about you boat but I believe your boat has catalytic exhaust. I would think that the risers running unusually hot will affect the cats and could cause a lean code. Kind...
That is the transmission cooler. I would think skidim.com could get that for you or a search on ebay
I don't like to rely on a cover alone and it is nice to be able to air the boat out after use to cut down on condensation.
Do you have anything like this available to you?
...
Like docdrs said above.
I believe this is the nipple I used but it would be best to double check your size, there are a few sizes and angles available.
...
First let me say that I have never used it on a boat or seen a boat that I was positive it was used on.
With that said when I would try to wash and compound/wax the black gelcoat on one of my...
I can't tell for sure but it looks like somebody used that poli-glow / mop-n-glo stuff on your boat at some point.
To me it looks like you are not using a fine enough sand paper before you switch to compound and polish. I usually work my way up to 2,000 grit before I switch to a compound/polish.
That is how...
I took about 6 trash cans of wet foam out of my boat at about 100 pounds each. Some people say they have taken close to 1,000 pounds out but not sure how accurate that is. My friends Malibu sunsetter...
I used Carbon Core when I rebuilt my Brendella Super Comp. It has strong points to it for sure. The only weak point I can think of is that it is so strong and dense that it makes the hull resonate...
Fuel economy in boats is more related to weight and drag of the boat than it is the engine.
I have a bbc Pirata and all things considered it is a very fuel efficient boat.
I think your boat must be wet. I don't think the bump behind your boat should be worse than a Prostar 190.
I have not skied behind the model boat you have but I have skied behind a variety of...
If the accelerator pump will only squirt fuel once check that the linkage is following the cam properly. It is common for the shaft to get corroded and the linkage does not follow properly. The lever...
That is easy to verify. Is the accelerator pump squirting fuel?
Check the easy stuff first. Look down the throat of the carb, if the floats are stuck it will be leaking fuel and flooding the engine. Very common with the Holley carbs.
https://www.youtube.com/watch?v=2sQJPZYSoUI
Fuel injection is great for turbos and such but not really needed for a old v8
It is not worth that much to me, not sure it would be worth half that much to me. But that is just me, maybe to someone else it would be worth that much.
That is the thing with boats, you just...
I have the same problem on my Pirata. The inlet on the gas tank points horizontally towards the back of the boat so the hose that connects to the gas fill fitting has a very sharp bend to the point...
Nice! My buddy I ski with gets down to 28 off at 31 mph but still can't get through the course 15 off at 32mph haha. It is crazy how much harder it seems picking up the speed just 1 mph.
Me skiing...
I got a 67, same as my theory. I am 180 with vest.
At 28 and 29mph I am early and coasting to the ball and the ski sinks a bit and takes a lot of effort to get going. The theory doesn't get bogged...
First off, I am a novice slalom skier. I never rode a ski until the end of 2014 and I was to lazy to fill fat sacs so I tried my friends slalom ski.
I was hooked on the speed and the fact that I...
Got a new ski today, 2016 Senate graphite with the hrt. I am not sold on the hrt but I thought I would give it a try and if I don't care for it one of my friends will want it for sure.
Stepped up...
That is basically what I did with my boat. If I end up rebuilding my Supra I am not sure if I would do it the same way.
When I replaced the floor on my Pirata the main stringers were pretty solid...
I rebuilt a boat with Carbon Core. I am happy with the over all experience and results.
http://www.carbon-core.com/carbonbond-transom.htm