Search:

Type: Posts; User: Mr717

Search: Search took 0.01 seconds.

  1. Sticky: Details? Where's it gonna be? Sent from my...

    Details? Where's it gonna be?

    Sent from my SM-G920V using Tapatalk
  2. Replies
    9
    Views
    607

    Haven't looked at surf tabs. I already have the...

    Haven't looked at surf tabs. I already have the 1100# bags. I think. Cause they are definitely aftermarket. That said, the wake shaper made a pretty substantial difference. Only had the boat...
  3. Replies
    9
    Views
    607

    Well I'm looking forward to the responses on this...

    Well I'm looking forward to the responses on this one. I just bought a 2014 Supra 242 Launch and I love the boat. The electronics can be a bit annoying sometimes. I've got the over size rear bags...
  4. That's correct. The pump for the engine is...

    That's correct. The pump for the engine is attached to the engine, via brackets and drive belts. Then you have the 3 separate pumps for the ballast tanks. I have a 2014 242 Launch and my 3 pumps...
  5. Replies
    16
    Views
    971

    I'll definitely check and see what they have to...

    I'll definitely check and see what they have to say. Thanks. I've mentioned the issues I've ran into and they hadn't offered any specific fix. But I'll ask more specific about the firmware update. ...
  6. Replies
    16
    Views
    971

    Hey just curious with you fellas, just picked up...

    Hey just curious with you fellas, just picked up my 2014 242. It's got the big screen for all the controls. Not sure which models have that which don't. Love the boat, but I seem have some kind of...
  7. Replies
    10
    Views
    882

    Lol. I've got the 2014 242 Supra and same issue....

    Lol. I've got the 2014 242 Supra and same issue. I just took the damn thing off. I'm hoping someone has some suggestions. Cause the one on my boat is more of a hindrance than anything. I've just...
  8. 10 years old and 560 hours doesn't sound too bad...

    10 years old and 560 hours doesn't sound too bad to me. And if you really trust the dealer your dealing with (that's always a gamble, lol. But they may be more willing to stand behind what their...
  9. Replies
    11
    Views
    743

    Update. Pulled my rudder, cause I got to looking...

    Update. Pulled my rudder, cause I got to looking at it and didn't look straight. Damn shaft was bent at the base. The shaft end was bent back about 3/4 of inch. Was able to press it back straight...
  10. Replies
    6
    Views
    548

    Lol. In Lake Livingston (Texas). Damn thing is...

    Lol. In Lake Livingston (Texas). Damn thing is full of trees. Was in open water 14' deep, doing 20mph, pulling my daughter on a tube. Hit a tree that must have been about 3' below water height. ...
  11. Replies
    6
    Views
    548

    I had a Rinker 246 Captiva 2008 I bought from a...

    I had a Rinker 246 Captiva 2008 I bought from a buddy that supposedly did impeccable maintenance, lol, not. First time out last year in November it was doing the same thing as yours. Would idle...
  12. Replies
    6
    Views
    548

    Sounds like bad gas, moisture in the distributor...

    Sounds like bad gas, moisture in the distributor breaking down the spark at anything above idle. Look at the distributor, wires, plugs and smell your gas. All this blended gas wreaks havoc on...
  13. Replies
    11
    Views
    743

    10 4 . I'll make sure and give an update on...

    10 4 . I'll make sure and give an update on this. Thanks again. I was getting ready to rebuild the rudder assembly. Lol.

    Sent from my SM-G920V using Tapatalk
  14. Replies
    11
    Views
    743

    10 4. I'll pull it and have it sent in and...

    10 4. I'll pull it and have it sent in and checked. Assuming mine is stock. Was wanting to use it this weekend. This might shut that down. It's always something.
    Thanks

    Sent from my...
  15. Replies
    11
    Views
    743

    I'd say the side to side is about a 1/4-3/8" at...

    I'd say the side to side is about a 1/4-3/8" at the the bottom of the rudder. That's if grabbing it from the bottom and pushing. Same slop on front to back. I was guessing with the force of all...
  16. Replies
    11
    Views
    743

    OK. I can do that. But just out of curiosity,...

    OK. I can do that. But just out of curiosity, wouldn't it have a consistent vibration and typically be noticeable at speed. So the rudder slop has nothing to do with the rattle? Thats what's...
  17. Replies
    11
    Views
    743

    The prop actually looks pristine. No indications...

    The prop actually looks pristine. No indications at all of contact with anything.

    Sent from my SM-G920V using Tapatalk
  18. Replies
    11
    Views
    743

    2014 Supra Launch 242 "rudder rattle"

    Just bought this boat about 2-3 weeks ago. It had 28 hours on it when I test drove it. When loading the boat there was a noticeable rattle in the steering wheel. Only when loading it on the...
Results 1 to 18 of 18