Search:

Type: Posts; User: asmithcveg

Search: Search took 0.01 seconds.

  1. This is the product I used to replace the window...

    This is the product I used to replace the window vent handle. It works. However, be prepared to drill out the aluminum (thankfully) rivets that affix the original bracket to the window frame. Note...
  2. Replies
    7
    Views
    257

    I'm located in northwest arkansas. Now that I'm...

    I'm located in northwest arkansas. Now that I'm thinking about it, the choke plate never opens or closes - it more or less just stays in the same position. Now this is worrying me a bit because the...
  3. Replies
    7
    Views
    257

    Yea I just found the gap spec. Mine is close...

    Yea I just found the gap spec. Mine is close enough that I doubt it is really the issue - especially with a brand new coil installed.

    I'm wondering if I am simply not starting the engine...
  4. Replies
    7
    Views
    257

    I actually just replaced the coil, but it was...

    I actually just replaced the coil, but it was more or less a stock replacement coil for the 351 Ford. What gap did you set the plugs to? I set all of them to 0.035" I believe. Most of the gaps were a...
  5. Replies
    7
    Views
    257

    Timing or Carb Issue

    1989 Supra Mariah with the Ford pcm 351. Electronic ignition (installed by others). Rebuilt motor with about 360 hours on it.

    I've figured out my no spark issue during ignition. However, I still...
  6. Replies
    10
    Views
    555

    So Vince with skidim came in for the win...

    So Vince with skidim came in for the win (hopefully). The solution is to run a hot wire from the ignition terminal on the starter relay (should be the only empty terminal) to the hot side of the...
  7. Replies
    10
    Views
    555

    So I was wrong in my earlier response. It...

    So I was wrong in my earlier response. It actually has the petronix electronic ignition installed.
  8. I have an 89 Mariah with rotten stringers as...

    I have an 89 Mariah with rotten stringers as well. I plan on drilling a couple holes along the stringers and injecting Mineax Wood Hardener into it as a "band aid" type repair to get me through the...
  9. Replies
    10
    Views
    555

    It also does it in neutral reverse as well. The...

    It also does it in neutral reverse as well. The common component according to the Trans manual is the control valve unless both the forward and reverse clutch plates are warped. Any thoughts?
  10. Replies
    10
    Views
    555

    Thanks for the link - some good information in...

    Thanks for the link - some good information in there for sure.

    In regards to the transmission, the PCM manual states that a blockage in the control valve may be the culprit for my excessive prop...
  11. Replies
    10
    Views
    555

    351 Ford pcm with points. Located in northwest...

    351 Ford pcm with points. Located in northwest arkansas

    Edit: I should point out that someone has messed with the main wiring harness as evidenced by it being wrapped in electrical tape....
  12. Replies
    10
    Views
    555

    Starting Issue - 1989 Supra Mariah

    So I have a new to me boat with 360 hrs on the original motor. The seller advised me of a weird startup issue with it, but played it off as normal.

    Here's the issue (if it really is one): Both the...
  13. Replies
    8
    Views
    482

    Does anyone know how much water needs to collect...

    Does anyone know how much water needs to collect in the bilge before the pump automatically activates? I have an '89 supra Mariah that I just purchased. The pump works on manual.
Results 1 to 13 of 13