Search:

Type: Posts; User: Jetlink

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    8
    Views
    86

    More information would probably be helpful here...

    More information would probably be helpful here such information like year, engine and fuel delivery method.
  2. Replies
    4
    Views
    97

    They were round as I recall on mine with three...

    They were round as I recall on mine with three screw holes I thought.
  3. Replies
    4
    Views
    97

    The “new” pass through pitot pickups mount in two...

    The “new” pass through pitot pickups mount in two of the three holes from the old style, I have been running the newer style with just those two screws without issue for over six years now. If you...
  4. Most likely plywood, if you are pre-composite...

    Most likely plywood, if you are pre-composite stringers which is '91 then definitely plywood.
  5. Above the tank there should be an access panel to...

    Above the tank there should be an access panel to remove that pump from the tank, have you looked there?
  6. Thread: Trailer bunks

    by Jetlink
    Replies
    2
    Views
    180

    I would personally stick with the carpet. If you...

    I would personally stick with the carpet. If you get the bunks wet enough and the trailer at the proper depth/angle you should not have any issues with loading or unloading the boat. You mention you...
  7. Replies
    6
    Views
    367

    I have a 160 degree thermostat on my boat as well...

    I have a 160 degree thermostat on my boat as well and running it on the hose I never see anything above 140 and on the water I see 150-160 usually in the heat of summer.

    You are good.
  8. Replies
    6
    Views
    459

    You are going to want to do some modifications to...

    You are going to want to do some modifications to that lift as the skegs, strut, prop shaft, prop and possibly rudder will all interfere with that lift as it is currently configured in your picture....
  9. Replies
    10
    Views
    747

    Since when? I was able to get a brand new one...

    Since when? I was able to get a brand new one from Skiers Choice a few years back when I did my restoration. Anyway, I did not drill a hole in the pan and just use it as a tray to trap what little...
  10. Replies
    5
    Views
    325

    Changing the oil before layup at the end of the...

    Changing the oil before layup at the end of the season is best as the oil is fresh. As you run the engine, the oil builds acidity and that then sits all winter eating at the engine. I would much...
  11. Replies
    1
    Views
    304

    Upgrading? Give me a shout when you are back up...

    Upgrading? Give me a shout when you are back up here again end of May.
  12. Replies
    4
    Views
    753

    First off, my ‘86 doesn’t have this anywhere on...

    First off, my ‘86 doesn’t have this anywhere on it so there is that. Second of all, when docking, the ability to quickly move around without killing the engine because you forget to untether the...
  13. Replies
    7
    Views
    357

    My trailer does not have a winch on it at all so...

    My trailer does not have a winch on it at all so I am all power load for the ski boat. We also have a big 24 foot Cobalt that has a winch but we dunk the trailer the exact same way and it works with...
  14. Replies
    5
    Views
    370

    The piece you are talking about is really there...

    The piece you are talking about is really there to secure the locker lid, the rear seat does not bolt or secure to anything and on my boat it is wedged in there for a tight fit.
  15. Replies
    7
    Views
    357

    You probably have the trailer too deep. When I am...

    You probably have the trailer too deep. When I am pulling the boat out of the water, we dunk the trailer to wet the entire bunk then pull the trailer out until the fender is usually just at the...
  16. Replies
    5
    Views
    370

    There is a small piece that fits over the top cap...

    There is a small piece that fits over the top cap piece at the front of the trunk locker. I will have to go back and look at how I built mine but if I recall correctly it was two pieces of plywood...
  17. Replies
    5
    Views
    370

    Rear seat is definitely able to be removed, the...

    Rear seat is definitely able to be removed, the "back" of the bench is usually all wood, I think I have pictures in under my username of the rebuild I did on mine over ten years ago, jeez cannot...
  18. Replies
    11
    Views
    825

    While I have zero experience nor a need for what...

    While I have zero experience nor a need for what you are embarking upon, I am always curious how others solve various problems. If anything, think of this thread or any thread in general as a way to...
  19. Replies
    71
    Views
    14,403

    Which place for the photo op of the Georgia Navy?

    Which place for the photo op of the Georgia Navy?
  20. Replies
    16
    Views
    2,973

    Matching years and matching trailers on the two...

    Matching years and matching trailers on the two '83 Supras? How did you manage that?
  21. Replies
    25
    Views
    2,285

    From another thread that highlighted the build...

    From another thread that highlighted the build slot allocation from Skiers Choice is probably the reason there. If there are 1200 new Moombas built to I think they said 500 new Supras, that ratio...
  22. Replies
    4
    Views
    441

    I have the "newer" style turnbuckles on my boat...

    I have the "newer" style turnbuckles on my boat now. Skier's Choice has them I believe.
  23. Did the seller indicate who did the stringer job?

    Did the seller indicate who did the stringer job?
  24. Replies
    17
    Views
    7,083

    But water weight is less than lead weight right?...

    But water weight is less than lead weight right? Clearly 1,100 pounds of water weighs less than 835 pounds of non water items.
  25. Replies
    114
    Views
    24,131

    I think they are just projects, some bigger than...

    I think they are just projects, some bigger than others but that is for an upcoming thread I believe.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4