The slots on my MEFI plug aren't labeled (per the directions on the offshoreonly website). Does anyone know which slot is which? I've got a 2003 indmar 320 TBI for reference.
Sent from my iPhone...
Type: Posts; User: kevbo5566
The slots on my MEFI plug aren't labeled (per the directions on the offshoreonly website). Does anyone know which slot is which? I've got a 2003 indmar 320 TBI for reference.
Sent from my iPhone...
Resolved. Turns out, all TPS's are not created equal and while the TPS I bought fit, it was sending the wrong signal to the TBI. One call to skidim and I had the correct sensor shipped, which solved...
The TPS was functioning properly after install (disengaged transmission and increased throttle), so I'm pretty sure it was installed correctly, it just was idling way too high with the new sensor....
I finally got down to the lake and continued to have issues starting it cold and also getting more power when increasing throttle (the problem diminished once the engine was warm), so I went out and...
I made the wake-shaper version this past weekend out of 1/2" HDPE, 2 gate hinges, 2 belt hinges, and a piece of telescoping aluminum. Works great and ran me $100 instead of $550.
I misspoke. I've got an Indmar Assault 320 hp TBI, not carb'd engine.
All,
I've got a 2003 Supra Launch SS (EDIT: Indmar Assault 320 HP TBI) and in neutral / at idle speed, there is sometimes white smoke / fuel droplets / a smell of gasoline coming from the exhaust....
I should have stated it, but the shaft is shreared off, so it's not possible to jam the prop with a 2x4 (since it's not attached anymore) to prevent the shaft from spinning. I was thinking maybe he...
How does the thrust bearing/drive flange connect to the forward end of the propeller shaft?
The mechanic we're using has said that he's going to need to remove the engine and transmission to get...
I don't know what happened, but it didn't sound or feel like I hit anything. Perhaps the torque released during the failure of the shaft bent it over, but as the picture shows, it's certainly bent.
...
I'm not sure how it happened, but after losing propulsion and assuming it was a transmission issue, it turns out my propeller shaft sheared in half directly in front of the strut. I haven't hit...
We were out on Lake Gaston yesterday afternoon, and as I accelerated to get on plane, we heard a rumble from the doghouse and lost all propulsion. The engine still runs, but I can no longer engage...
As an update, it appears the Idle Air Control Valve had gotten gummed up and dirty, so I replaced it and my issues seem to be resolved. Thanks for your help.
It's carbureted. I'm going to change the fuel filter next week, hopefully that solves my issue.
Ok, thanks. I just got a morning set in (problem persists), and we noticed a stronger smell of gasoline than normal. I'm not sure if the two are related, but wanted to report all symptoms.
All,
I just got down to the lake for a weekend of fun in the sun and went to start up my 2003 Launch SS (just passed the 500 hour mark), and upon startup the engine idled at about 400 rpm's,...
I attempted to replace my ballast pump with the Attwood pump from Amazon you reccomended Mike, but it appears that I'm not getting any power to the pump. The light on the switch is on, but I tested...
I realize this is an old thread, but since I have questions on the same 2003 Launch SS I figured I would post to this thread.
Does anyone know what type or where to find a replacement inline...
I just called Skidim and they were able to help me out with ease.
Here's a great "how-to" which is referenced elsewhere on the forums on how to repack the shaft packing...
...
I think I'm going to be replacing my steering cable in the next month. Are there any special tools I'll need, other parts, or things to be watchful of when replacing the cable? I plan to call...
We're on Gaston in Jimmy's Creek. When y'all get up that way, we'lll have to meet up. Just a few short months!
I couldn't be more excited to get the boat back in the water... We're planning to put the boat in the water in North Carolina March 31st and I'll hopefully get a chilly pull that day to test out the...
All,
My '03 Launch is showing it's age (and probably misuse) at the base of the wakeboard tower, in the form of cracking in the gel coat radiating outward from the bolt holes. I'm sure this has...
I'm planning to install a second battery with a Perko switch in my 2003 supra launch ss. My question concerns the size of the switch I need to purchase, based on the amps produced by the alternator....
I just removed my ski pole on my 03 Launch and found decent cover at Home Depot, in the form of an aluminum cover that's used when a ceiling fan fixture is roughed in, but not installed. I spray...