Search:

Type: Posts; User: michael hunter

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds; generated 3 minute(s) ago.

  1. Replies
    1
    Views
    45

    There are a couple embroidery shops here in...

    There are a couple embroidery shops here in northern Georgia that can duplicate them where are you located?
  2. Should be a machined hole leading down to a cam...

    Should be a machined hole leading down to a cam drive gear and in the center a hexagonal oil pump drive shaft about the size of a pencil. Take a picture of yours and post it.
  3. Replies
    2
    Views
    355

    What kind of fluid are you using? My 89 has been...

    What kind of fluid are you using? My 89 has been making a similar noise on cold starts for as long as I can remember[I bought it new] never had any drive problems. I painted the dip stick black so I...
  4. Replies
    1
    Views
    57

    You tube is your friend.

    You tube is your friend.
  5. Where are you located?

    Where are you located?
  6. Sounds like you may have the wrong carb. Where...

    Sounds like you may have the wrong carb. Where did you buy it . Are you sure its a marine carb?
  7. O’Reilly’s is useless for boats . Skidim is a...

    O’Reilly’s is useless for boats . Skidim is a good source. Where are you located?
  8. I would put in a HEI unit . Google marine HEI...

    I would put in a HEI unit . Google marine HEI distributor there are many outlets that carry them.
  9. Replies
    1
    Views
    120

    Centroid Products 386-423-3574. They custom make...

    Centroid Products 386-423-3574. They custom make a full electronic sender to your boats specs. No float to move around dash gauge stays rock solid . I use them in all my boats since 1989.
  10. Holley's do fine when set up correctly. If you...

    Holley's do fine when set up correctly. If you have not rebuilt the Holley then start there. If money is no factor just buy a new exact replacement to the OE carb. If you go with the Edelbrock you...
  11. Does it still have points?

    Does it still have points?
  12. Replies
    2
    Views
    225

    What year? Where is it located? Can you post...

    What year?
    Where is it located?
    Can you post picks?
  13. Replies
    1
    Views
    149

    Try posting to Imgur then transfer to the forum.

    Try posting to Imgur then transfer to the forum.
  14. I work part time for a company called Cover Girl...

    I work part time for a company called Cover Girl . She does vinyl and canvas boat repairs. I do all the rotted wood repairs so she can cover them. I have found that by the time I get a rotted wood...
  15. 10k for a 96 doesn't sound too high depending on...

    10k for a 96 doesn't sound too high depending on condition?
  16. I don't get this post you ask for help but don't...

    I don't get this post you ask for help but don't give any location and then you get someone from CT willing to go anywhere to look for you? Did miss something?
  17. Replies
    2
    Views
    222

    There are lots of posts about stringers . After...

    There are lots of posts about stringers . After you get the old floor up check the stringers for rot. You may have to remove some foam to get to the stringers. The 84 comp I did used 5/8 plywood for...
  18. I said I hope it all works out for you .

    I said I hope it all works out for you .
  19. Replies
    2
    Views
    205

    Why did you replace it?

    Why did you replace it?
  20. Replies
    4
    Views
    338

    Only one I found was 172.95 from Perko. I have...

    Only one I found was 172.95 from Perko. I have been boating for 35 years and never anchored at night . All I needed was a running light. I bought a 2 pin from amazon for 17.00
  21. Replies
    4
    Views
    338

    I bought the 2 pin nav light had to remove the...

    I bought the 2 pin nav light had to remove the lower plug assb and move the left side connector on the light to the center. You will loose the anchor light capability but the running light will work...
  22. Replies
    2
    Views
    227

    If the battery's are good and the wires going the...

    If the battery's are good and the wires going the the starter are good you probably need a starter . Sometimes the local auto supply store has a machine to test the starter.
  23. Replies
    4
    Views
    338

    I am also looking for a three pin nav light for...

    I am also looking for a three pin nav light for my comp. They seem to be no longer available . I will probably just replace the whole thing with a 2 pin since we never anchor at night anyway.
  24. Where is the boat?

    Where is the boat?
  25. Try starting the engine and tapping on the MAS...

    Try starting the engine and tapping on the MAS with the back of a screwdriver. Any change in the running replace the sensor. Look carefully at the sensor GM normally puts numbers on them.
Results 1 to 25 of 495
Page 1 of 20 1 2 3 4