Search:

Type: Posts; User: joe Schnur

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. Replies
    8
    Views
    2,411

    No gap and mine does not flex

    No gap and mine does not flex
  2. Replies
    8
    Views
    2,411

    Would be very surprised to have hull flex on this...

    Would be very surprised to have hull flex on this boat
  3. Replies
    7
    Views
    1,872

    Yes well horror story dealer rebuilt carb did a...

    Yes well horror story dealer rebuilt carb did a crappy job said primaries were flooding over not the case the primary bowl is leaking because the needle valve is sticking trying to figure out why.
    ...
  4. Replies
    7
    Views
    1,872

    New fuel pump too

    New fuel pump too
  5. Replies
    7
    Views
    1,872

    Mariah 351 surges at low speed

    My dealer is working on the boat and is having trouble with the above problem .

    Runs great at high speed. At low speed and idle it surges.

    Work done wires , plugs, coil , ballast resistor,...
  6. Replies
    1
    Views
    9,339

    Going to look into 3d printing a new stronger...

    Going to look into 3d printing a new stronger hinge
  7. Replies
    7
    Views
    56,027

    Sticky: Thanks for the honest and concise letter

    Thanks for the honest and concise letter
  8. Replies
    13
    Views
    6,704

    Awesome keep em common it was amazing

    Awesome keep em common it was amazing
  9. Thread: 92 Mariah

    by joe Schnur
    Replies
    2
    Views
    1,463

    Don't let the bow dive or you will swamp the front

    Don't let the bow dive or you will swamp the front
  10. Replies
    3
    Views
    1,150

    Rebuild and replace floats with brass ones from...

    Rebuild and replace floats with brass ones from summit racing my plastic ones were flooding the engine with gas
  11. Rebuilt carb had to adjust the idle screw way...

    Rebuilt carb had to adjust the idle screw way down the engine was pulling gas through and flooding also had to replace the floats with brass ones
  12. Thinking about coil just frustrating in garage...

    Thinking about coil just frustrating in garage now. Will take to shop in march if I get no new ideas
  13. 1991 Mariah PCM 351 stalls after a few seconds

    Thanks Chris new hose in place 6 to 10 secs idled to the end of lake after a weekend of skiing pulling a barge. On drive back to the dock it just would not stay running and killed the batt trying to...
  14. Well carb rebuilt still no joy

    Well carb rebuilt still no joy
  15. Replies
    14
    Views
    8,903

    supra comp stringer restoration

    Build frames take thousands of measurements

    Frames to align the engine mounts mark al, the holes on the alignment frames and put them aside will make realigning everything much easier
  16. Replies
    11
    Views
    66,622

    Did what you all suggested ended up with a Radar...

    Did what you all suggested ended up with a Radar Senate 71" very happy
  17. 1991 Mariah PCM 351 stalls after a few seconds

    Still not working

    Pulling and rebuilding carb
  18. Replies
    34
    Views
    113,564

    Sticky: Tool dip comes in colors and is paintable

    Tool dip comes in colors and is paintable
  19. 1991 Mariah PCM 351 stalls after a few seconds

    Accelerator pump always works. Cut 1.5 inches off each end of the hose . Blew out the check valve on the tank retightened everything engine runs rough probably due to the hose being stretched over...
  20. Will try the screws it is not just an idle issue...

    Will try the screws it is not just an idle issue I rev the engine to keep it running it eventually dies. Yes initially the pump will squirt fuel.
  21. Doesn't seem to be flooding seems to be starving

    Doesn't seem to be flooding seems to be starving
  22. Replies
    14
    Views
    5,314

    Put non skid on top surfaces near the winch hurts...

    Put non skid on top surfaces near the winch hurts like a sob to slip and get a leg caught in between the xmembers. While pulling the boat on the trailer. Will maybe save some serious injury.
  23. 1991 Mariah PCM 351 stalls after a few seconds

    Replaced fuel filter fuel pump still runs and roughens up and stalls. Please give me some where to look. Thinking about looking at replacing the fuel lines next .

    No leaks pressurizedk tank and...
  24. Replies
    7
    Views
    2,780

    Post the good Michigan stringer company here

    Post the good Michigan stringer company here
  25. Replies
    11
    Views
    66,622

    Thankyou I will look into it Staff shooter...

    Thankyou I will look into it


    Staff shooter Dream Shot Archery makers of Twisted Minds bowstrings.
    Hoyt Pro Comp Elite XL 51#
    AXcel Acheive sight. Hamskea rest
Results 1 to 25 of 28
Page 1 of 2 1 2