Search:

Type: Posts; User: Jetlink

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    3
    Views
    458

    Thanks, I nearly spit out my drink reading that.

    Thanks, I nearly spit out my drink reading that.
  2. Well this escalated quickly.

    Well this escalated quickly.
  3. Replies
    1
    Views
    901

    I replaced the rudder on my Comp beginning of the...

    I replaced the rudder on my Comp beginning of the season as the seals were toast and you cannot get parts for it anymore. Ordered this and have had zero issues since install....
  4. Replies
    5
    Views
    1,955

    Wish I could say that this is a shock to me but...

    Wish I could say that this is a shock to me but alas, these older boats are getting harder to get parts for. I will stop in at my dealer tomorrow and see if they can reference the part for you.
  5. Replies
    10
    Views
    3,689

    Iíll save you the math, the two of you are about...

    Iíll save you the math, the two of you are about 8-9 hours driving one way between you depending on where in southeast Michigan you are.
  6. Replies
    5
    Views
    1,955

    What year Comp? I was able to get an all...

    What year Comp? I was able to get an all composite/plastic drivers seat shell from Skiers Choice, ordered through my local Supra dealer about 5 years ago. I had it covered and everything and the best...
  7. Replies
    3
    Views
    358

    Honestly, the engine (aside from needing a...

    Honestly, the engine (aside from needing a rebuild) is fine, the prop is where you get the boat truly setup and dialed in for your application with your power available. Plus a prop is usually in the...
  8. Thread: 99 Legacy

    by Jetlink
    Replies
    2
    Views
    379

    No real manual to speak of, there are engine...

    No real manual to speak of, there are engine manufacturer manuals out there though. Best bets are to drain the gas because it is most certainly bad. Check hoses for condition especially the fuel...
  9. Replies
    1
    Views
    257

    Should work as the difference between the Saltare...

    Should work as the difference between the Saltare and the Pirata was the top cap I believe.
  10. Replies
    3
    Views
    745

    Put me down for a shirt too!

    Put me down for a shirt too!
  11. Does the rudder have any trim tabs on the...

    Does the rudder have any trim tabs on the trailing edge of the rudder? I know that is a thing on some boats and might be worth checking out.
  12. Replies
    16
    Views
    1,681

    More information would probably be helpful here...

    More information would probably be helpful here such information like year, engine and fuel delivery method.
  13. Replies
    5
    Views
    614

    They were round as I recall on mine with three...

    They were round as I recall on mine with three screw holes I thought.
  14. Replies
    5
    Views
    614

    The “new” pass through pitot pickups mount in two...

    The “new” pass through pitot pickups mount in two of the three holes from the old style, I have been running the newer style with just those two screws without issue for over six years now. If you...
  15. Most likely plywood, if you are pre-composite...

    Most likely plywood, if you are pre-composite stringers which is '91 then definitely plywood.
  16. Above the tank there should be an access panel to...

    Above the tank there should be an access panel to remove that pump from the tank, have you looked there?
  17. Thread: Trailer bunks

    by Jetlink
    Replies
    2
    Views
    341

    I would personally stick with the carpet. If you...

    I would personally stick with the carpet. If you get the bunks wet enough and the trailer at the proper depth/angle you should not have any issues with loading or unloading the boat. You mention you...
  18. Replies
    6
    Views
    778

    I have a 160 degree thermostat on my boat as well...

    I have a 160 degree thermostat on my boat as well and running it on the hose I never see anything above 140 and on the water I see 150-160 usually in the heat of summer.

    You are good.
  19. Replies
    6
    Views
    817

    You are going to want to do some modifications to...

    You are going to want to do some modifications to that lift as the skegs, strut, prop shaft, prop and possibly rudder will all interfere with that lift as it is currently configured in your picture....
  20. Replies
    10
    Views
    1,100

    Since when? I was able to get a brand new one...

    Since when? I was able to get a brand new one from Skiers Choice a few years back when I did my restoration. Anyway, I did not drill a hole in the pan and just use it as a tray to trap what little...
  21. Replies
    5
    Views
    549

    Changing the oil before layup at the end of the...

    Changing the oil before layup at the end of the season is best as the oil is fresh. As you run the engine, the oil builds acidity and that then sits all winter eating at the engine. I would much...
  22. Replies
    1
    Views
    413

    Upgrading? Give me a shout when you are back up...

    Upgrading? Give me a shout when you are back up here again end of May.
  23. Replies
    4
    Views
    1,335

    First off, my ‘86 doesn’t have this anywhere on...

    First off, my ‘86 doesn’t have this anywhere on it so there is that. Second of all, when docking, the ability to quickly move around without killing the engine because you forget to untether the...
  24. Replies
    7
    Views
    541

    My trailer does not have a winch on it at all so...

    My trailer does not have a winch on it at all so I am all power load for the ski boat. We also have a big 24 foot Cobalt that has a winch but we dunk the trailer the exact same way and it works with...
  25. Replies
    5
    Views
    630

    The piece you are talking about is really there...

    The piece you are talking about is really there to secure the locker lid, the rear seat does not bolt or secure to anything and on my boat it is wedged in there for a tight fit.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4