Search:

I would say that prop is way to far forward. Here is a link to a good photo of a Moomba.

http://www.moomba.com/msgboard/showthread.php?17988-Prop-Rudder-Clearance-Help/page2

You tap it with a brass or aluminum drift. Careful not to damage threads.

Had not thought of weight issue, but I did not notice much of a list to these boats. If is turns out to be a issue I may move the batteries to the port side.

I put a new Edelbrock Marine carb on mine, works great. Under $400 new. I have the old factory carb, but it needs a rebuild.

I will look, but I think they are already gone.

Well all of the action is out the rear of the boat, so now passengers will be able to look out the back all the time. The taller front seats swivel so front passenger can face front or rear. The...

Nearing the end of a 2 month rebuild of my 89 Conbrio. Purchased this boat early last season at salvage auction. We had a great summer, putting almost 30 hours on the boat. But, it liked to drive...

Do you know how far back it fits. I have a 1987 Sunsport that I am using as a parts boat.

The adjustable trim plate on my 89 Conbrio was damaged when I puchased boat. I bent it back into place best Icould, but I think it maybe effecting boat. Turns harder to the right, and not sure...

Also if you have a battery jump pack, or jumper cables, connect them drectly to the motor. Neg to block and poss to battery side of the starter seliniod. This will by pass any bad cable issues. ...

Did the boat run before it sat for two years ?? Check distributor placement, pull number one plug, put a strall or something stiff but not damaging in the hole, turn crank with wrench till piston...

My 89 Conbrio says 6 people or 850 lbs

10430 Well after two weeks of repair and cleaning to my 89 Conbrio pay off. On the water saturday and sunday put over seven hours on the Supra and it ran great. Kids had a great time on the tube...

Sorry, 1989 Supra with a PCM 40 1.23 ratio. Had water in trans, hope I did not run it to long !!

Working away on my flood boat, thing are going ok. Engine is running, got all all the electric working, but I have a gear noise if I turn the driveshaft by hand. Sounds like a manual trans that is...

Should get more sleep before typing. Long day yesterday

Picked up my 1989 Supra Conbrio at the auction yesterday. They broke the rudder of and lost it !!! Any idea if the rudder from my 86 Sunsport parts boat will fit ??

Thanks Brent

Thanks for the info guys! Hope all is good with my Supra and be boating on Fathers Day.

I just purchased this boat at salvage auction with the info that it runs, but has water damage. Hoping for the best but really know very little about the boat. Just knew I wanted a ski/wake boat in...