Search:

Type: Posts; User: luke22885

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    21,007

    Replacing interior 05 21V

    Good morning-
    I am looking to replace the entire interior of my 2005 21V and was wondering if anyone has done this before. Does Supra make skins that can be purchased? I had emailed the closest...
  2. Replies
    1
    Views
    1,650

    What’s a good stereo battery?

    I have a 2005 21v and need to replace the second battery for the stereo. Any suggestions on a good one? Had 2 regular die hard deep cycle batteries the last few years but just the cheap ones. I read...
  3. Screws for swim platform bracket ripped through transom 05 21v

    14765

    So over the weekend, I had the top bolts rip out of the transom of the boat as shown in the attached picture. Has anyone had this happen before? I tried looking at the backside but it...
  4. Question when redoing the prop shaft packing on 05 21v

    I tightened the packing last year after i noticed it was leaking too much and it was ok for a while but just put boat in for first time this year on Saturday and it was back to leaking pretty good. I...
  5. Replies
    11
    Views
    13,673

    I think I just deleted picture of it off my phone...

    I think I just deleted picture of it off my phone yesterday. I am going up to where I store the boat tonight and can take a picture and email it to you, text it, or try and post it up one here if...
  6. Replies
    11
    Views
    13,673

    I was in the exact same situation you are in now...

    I was in the exact same situation you are in now last year when I bought my 05 21v that had no pad on it at all. Through this site i was told to contact [email protected]. I got a custom...
  7. Replies
    33
    Views
    13,478

    Thanks man, thats exactly what I was looking for....

    Thanks man, thats exactly what I was looking for. Family is all plumbers so i know we have some of that laying around at the cottage. Will give it a try tonight.
  8. Replies
    33
    Views
    13,478

    I have the same problem. Cut a small hole in it...

    I have the same problem. Cut a small hole in it to fit shop vac but only sucked what I could on top of the foam. This weekend I plan to go through the foam to see if I can get more water out. I have...
  9. Replies
    1
    Views
    1,065

    Vinyl question on 05 supra

    I have a 05 21v and the two corner cushions need to be redone due to cracking on the sides and 1 has a 2" slit on the top. Is there a place I can buy that same type of vinyl to get it to match the...
  10. Replies
    20
    Views
    9,464

    Cool, I appreciate all the help and the pictures....

    Cool, I appreciate all the help and the pictures. Should be much better than my 2 6.5 inch cans I had before
  11. Replies
    20
    Views
    9,464

    Ok leaning towards 10s now. Have an amp that will...

    Ok leaning towards 10s now. Have an amp that will power either pair and was told 10s would sound better due to size
  12. Replies
    20
    Views
    9,464

    Where you have those mounted there's a good area...

    Where you have those mounted there's a good area to walk in the middle? Hard to tell from angle. I really want the 10s just nervous about the size.
  13. Replies
    20
    Views
    9,464

    Looks great and I'm sure sounds even better. I am...

    Looks great and I'm sure sounds even better. I am currently adding another amp, sub and revs to my 05 21v and have two questions if you don't mind. How did you mount the amp rack on the side like...
  14. I am planning on taking a lot of time to do it...

    I am planning on taking a lot of time to do it the right way. Are you saying you would cut the floor or wouldnt? I was thinking not cut it all the way out but just put some kind of slit that i can...
  15. I bought a 12 inch jl 12w3 and the enclosure...

    I bought a 12 inch jl 12w3 and the enclosure recommended is a bass-reflex (tuned port) that is 2.966 cu ft. With dimensions I took the first size template I built to try was 17” H X 21” W X 15” D. ...
  16. Adding a sub to '05 21v need some help with enclosure

    So I purchased a second amp and sub to add as a winter project to my boat which did not have a sub in it before. I was given a lot of help by the place I purchased the equipment from as far as what...
  17. Vinyl issue on center section of rear deck on 05 21v

    So this is was the first big weekend of using my new to me boat and I noticed an issue that I was wondering if anyone else encountered. There were two very small tears about 1/4 inch near the lock...
  18. Replies
    5
    Views
    2,159

    Ok I was thinking about trying to get a new gauge...

    Ok I was thinking about trying to get a new gauge as well since the plate goes up and down with no issues but just was trying to see if there was something else to look at before i did so.
  19. Replies
    5
    Views
    2,159

    Wakeplate gauge issue on a 05 21v

    So i bought my new to me boat in November and the gauge was working fine. Used the boat a couple times this year so far and sometimes the gauge works sometimes it doesnt. First time out this year...
  20. Replies
    16
    Views
    6,031

    It is textured material. I had a better picture...

    It is textured material. I had a better picture with my good camera but could not get it to upload. so had to stick with the cell pic
  21. Replies
    16
    Views
    6,031

    9160 This thing turned out awesome

    9160

    This thing turned out awesome
  22. Replies
    2
    Views
    1,736

    THanks for the info I ended up finding the right...

    THanks for the info I ended up finding the right one by contacting indmar for part number.
  23. Replies
    2
    Views
    1,736

    Please help... Distributor cap and rotor?

    I have a 2005 21v and need a new rotor and distributor. I called supra dealer and they sent me a mercury one #808483k2. I don't have the old one and my boat is 2 hours away but the rotor definitely...
  24. Replies
    16
    Views
    6,031

    Yes it is definately Jim at Viper Customs. Told...

    Yes it is definately Jim at Viper Customs. Told me he could of done the stock pad but highly recommended the sea dek along with many others. I was doing google searches looking for something...
  25. Replies
    16
    Views
    6,031

    Its going to be black with storm grey supra logo....

    Its going to be black with storm grey supra logo. Approx $220 and as far as edges not 100% sure what you mean. I saw a picture of a grey one with black letters this guy made for another 05 21v and I...
Results 1 to 25 of 31
Page 1 of 2 1 2