First off, my ‘86 doesn’t have this anywhere on it so there is that. Second of all, when docking, the ability to quickly move around without killing the engine because you forget to untether the...
Type: Posts; User: Jetlink
First off, my ‘86 doesn’t have this anywhere on it so there is that. Second of all, when docking, the ability to quickly move around without killing the engine because you forget to untether the...
My trailer does not have a winch on it at all so I am all power load for the ski boat. We also have a big 24 foot Cobalt that has a winch but we dunk the trailer the exact same way and it works with...
The piece you are talking about is really there to secure the locker lid, the rear seat does not bolt or secure to anything and on my boat it is wedged in there for a tight fit.
You probably have the trailer too deep. When I am pulling the boat out of the water, we dunk the trailer to wet the entire bunk then pull the trailer out until the fender is usually just at the...
There is a small piece that fits over the top cap piece at the front of the trunk locker. I will have to go back and look at how I built mine but if I recall correctly it was two pieces of plywood...
Rear seat is definitely able to be removed, the "back" of the bench is usually all wood, I think I have pictures in under my username of the rebuild I did on mine over ten years ago, jeez cannot...
While I have zero experience nor a need for what you are embarking upon, I am always curious how others solve various problems. If anything, think of this thread or any thread in general as a way to...
Which place for the photo op of the Georgia Navy?
Matching years and matching trailers on the two '83 Supras? How did you manage that?
From another thread that highlighted the build slot allocation from Skiers Choice is probably the reason there. If there are 1200 new Moombas built to I think they said 500 new Supras, that ratio...
I have the "newer" style turnbuckles on my boat now. Skier's Choice has them I believe.
Did the seller indicate who did the stringer job?
But water weight is less than lead weight right? Clearly 1,100 pounds of water weighs less than 835 pounds of non water items.
I think they are just projects, some bigger than others but that is for an upcoming thread I believe.
Some gloss black on that wheel should hide it better.
Got any pictures of the wake that you are getting now along with the settings/configuration of the boat for that wake?
Follow the water is what you need to do. The water pickup is to the right in your picture, just follow the two inch hose with the green stripe on it and disconnect along the way. I disconnect both...
What Michael said, the only hoses you really should be taking apart are hoses that have water going through them. All hoses should be of the two inch diameter variety and have hose clamps on them if...
My battery switch is located right at the helm on my boat. Not sure when Supra went away from that but they had it right in '86 at least. :p
Well aren't you a downer there.
I bet we have found your problem right here.
This boat also falls into the range of Pro-Tec ignition as well. If it has it that could also be an issue.
If you drill one hole in each side of the lower windshield frame for the bimini mount, then drill into the rub rail for the straps and that should eliminate any drilling into the top cap and as an...
Wait, there are now Wake Ships in addition to the Wake Boats?
What Mr. Hunter said. You will get a good boat and a good wake without spending more money than needed.