Search:

Type: Posts; User: michael hunter

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Mine is a 89 i'm not sure its the same as yours a...

    Mine is a 89 i'm not sure its the same as yours a pic of your dash would help. The warning lights on the dash generally don't work the control box that runs them had all kinds of problems. I...
  2. If you are running points start there, As a rule...

    If you are running points start there, As a rule they should be replaced every year or so. At minimum reset the point gap .The point gap for a Prestolite distributor is .018'' dwell is 29 to 33...
  3. You will have to check with Mallory on...

    You will have to check with Mallory on installation instructions. I like the DUI ignition system I have it on 3 of my 351w boats all run great.
  4. If you replace the relay you must get a high...

    If you replace the relay you must get a high quality heavy duty relay. The stuff sold at the big box auto parts stores are junk. I replaced the starters on two of my Supras with a gear reduction...
  5. That i term is usually not used with electronic...

    That i term is usually not used with electronic ignition . I am not familiar with the mallory set up . All of my boats are running DUI . If you have 3 dead cylinders you should start with a...
  6. Replies
    3
    Views
    85

    I had to drill 4 holes in the gunnel for the...

    I had to drill 4 holes in the gunnel for the center mount . The front straps are mounted to the rub rail the rear attach to the grab rail.
  7. I have one off of a working 86 comp if you need.

    I have one off of a working 86 comp if you need.
  8. Replies
    5
    Views
    82

    The shaft on mine is 6'' long and 1 1/8''...

    The shaft on mine is 6'' long and 1 1/8'' diameter. I do have the the complete assembly including the port and arm.
  9. It depends on what brand of electronic ignition...

    It depends on what brand of electronic ignition you have . You will have to contact the manufacture to get the install instructions.
  10. Replies
    1
    Views
    70

    It looks like you are still running points...

    It looks like you are still running points ignition. I would start there . Where are you located?
  11. Replies
    3
    Views
    85

    I don't believe they came with a bimini . My 89...

    I don't believe they came with a bimini . My 89 didn't. If you google boat bimini top there tons of places that sell them. You will need to measure the with and height you want . I got one from...
  12. Are you talking about a Malibu Sunsetter or a...

    Are you talking about a Malibu Sunsetter or a Supra Sunsport ? I don't know what a Sundowner is?
  13. Replies
    5
    Views
    82

    I have one off a 86 comp . Give me the shaft...

    I have one off a 86 comp . Give me the shaft measurements and I will check.
  14. Replies
    1
    Views
    124

    You need the PCM manual . You can find it on...

    You need the PCM manual . You can find it on CorrectCraftFan.com in the reference section.
    A good place to find PCM parts is Skidim.com
    I like Etrailer for trailer parts.
  15. There is a number stamped into one end of the...

    There is a number stamped into one end of the cable housing that will get you an exact match.
  16. I might have one . PM me with a picture of what...

    I might have one . PM me with a picture of what you need.
  17. I agree a project boat is not for everyone but...

    I agree a project boat is not for everyone but there are a lot of people with more money than knowledge of what it takes to restore one of these boats especially with missing parts . I would offer...
  18. Replies
    3
    Views
    85

    Did you check the bulbs? Remove the covers and...

    Did you check the bulbs? Remove the covers and check for power and ground .
  19. Replies
    2
    Views
    471

    Yes and yes just make sure you hook them up to...

    Yes and yes just make sure you hook them up to correct polarity.
  20. What electronic ignition brand are you running ?...

    What electronic ignition brand are you running ? Some of the electronic conversion system were problematic.
  21. Replies
    12
    Views
    207

    It could be the starter or the battery cables or...

    It could be the starter or the battery cables or connections. Do you have the 454 or the 351?
  22. Are you still running points?

    Are you still running points?
  23. Skeg or shaft could be bent . It may also need...

    Skeg or shaft could be bent . It may also need new cutlass bearings. Did you check the shaft alignment?
  24. Replies
    8
    Views
    224

    Anything you do with that boat will be survival...

    Anything you do with that boat will be survival sking . Your best bet is to get a comp or a friend with a comp.
  25. I have a 85 intact comp hull it will need...

    I have a 85 intact comp hull it will need stringers but you can have it for free
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4