Search:

Type: Posts; User: michael hunter

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    8
    Views
    1,872

    Take the old sender out and measure the depth of...

    Take the old sender out and measure the depth of the tank . They will make one compatible with VDO.
  2. Replies
    5
    Views
    362

    Make sure you buy the marine distributor set up

    Make sure you buy the marine distributor set up
  3. Replies
    8
    Views
    1,872

    More like the forth one never had any problems...

    More like the forth one never had any problems with them.
  4. Replies
    5
    Views
    362

    Its a very easy hook up 2 wires one comes from...

    Its a very easy hook up 2 wires one comes from the ign side of the ballast resister to the batt side of the dist cap . The other comes from the neg side of the coil its the gray wire it goes to the...
  5. Replies
    2
    Views
    256

    A V drive will have a worse ski wake. They are...

    A V drive will have a worse ski wake. They are only better for wakesurfing and maybe wakeboarding.
  6. Replies
    21
    Views
    1,748

    I don't know the system you installed . Start...

    I don't know the system you installed . Start with the 50 amp red breaker at the back of the engine above the trans. Recheck your wiring. You spent a ton of money on that stuff you should ask what to...
  7. Replies
    8
    Views
    1,872

    It will eliminate the fluctuations . Very easy to...

    It will eliminate the fluctuations . Very easy to change just remove the old sender and replace it with the new 2 wires and you are good to go.
  8. Replies
    8
    Views
    1,872

    Centroid Products 386-423-3574 they make...

    Centroid Products 386-423-3574 they make electronic senders not effected by waves. You will need to know how deep the tank is and what brand the gauge is . I put one in my 89 Sunsport in 89 still...
  9. Replies
    10
    Views
    2,739

    What is wrong with the engine? I have a 351 block...

    What is wrong with the engine? I have a 351 block with new cam bearings .
  10. Replies
    5
    Views
    1,320

    Google Perfect pass troubleshooting for...

    Google Perfect pass troubleshooting for troubleshooting information.
  11. You probably have a Pro Tech system. There are no...

    You probably have a Pro Tech system. There are no more parts available anymore. Your best solution is to convert it to a DUI [Davis Unified Ignition] system very simple unless you have fuel injection.
  12. I have never heard of water causing a melted...

    I have never heard of water causing a melted piston. If you had that much water in the fuel there would be a lot of other symptoms such as
    Rough acceleration
    Misfires
    Rough idle
    Check engine...
  13. What exactly is wrong with the engine? Is there...

    What exactly is wrong with the engine? Is there water in the oil. They will have to prove you did something to damage it not just make up a story. Did you contact Supra and start a warranty case...
  14. Replies
    2
    Views
    664

    You can run as long as the battery has power make...

    You can run as long as the battery has power make sure the belt is on the water pump.
    I have used db electric for starters and alternators with good results and price.
  15. Replies
    6
    Views
    1,331

    Only difference between closed bow and open is an...

    Only difference between closed bow and open is an open bow gets a wave of water over the bow and down the center aisle . On a closed bow it goes over the noise over the windshield and dumps in your...
  16. Replies
    6
    Views
    1,331

    I have 6 boats ranging from a 16' 67 Correct...

    I have 6 boats ranging from a 16' 67 Correct Craft Mustang 2 comps 1 Sunsport 1 Nautique 210 and a 25' Pontoon. It rarely happens but I have stuffed the nose on all of them. Its a matter of driver...
  17. Replies
    3
    Views
    665

    Is it cable or wire operated ? Check Morse...

    Is it cable or wire operated ? Check Morse controls at skidim.
  18. Thread: mike y

    by michael hunter
    Replies
    7
    Views
    446

    Check the fuel filter and fuel pressure.

    Check the fuel filter and fuel pressure.
  19. Replies
    4
    Views
    510

    This market is crazy . People are paying top...

    This market is crazy . People are paying top dollar plus for a decent boat. This too will pass most people don't stay in the sport especially when they find out how much work owning a boat is. The...
  20. Replies
    3
    Views
    438

    Yes it is a composite boat [no wood]. By the time...

    Yes it is a composite boat [no wood]. By the time you put a stereo , perfect pass, tower, upholstery and ballast system I question weather you would be better off to spend the extra money and buy a...
  21. The prop shop should be able to straighten it.

    The prop shop should be able to straighten it.
  22. Replies
    6
    Views
    600

    This is the best I have found . New from Fatsac ...

    This is the best I have found . New from Fatsac M3001 Party Bumper. Its 10' long and 20'' diameter. It fills in a few minutes with a 12volt tube inflator. Anyone that knows me knows I NEVER put my...
  23. Replies
    2
    Views
    301

    99 is a full composite boat so no worries about...

    99 is a full composite boat so no worries about rotted wood . Change all the fluids and filters make sure you buy a Sherwood impeller not an off brand [ skidim . com]
    if you can drain the gas tank...
  24. How hot did you get it? Its more likely you...

    How hot did you get it? Its more likely you cracked the block by freezing last winter and that caused the overheat. You would have to melt every hose and exhaust to get it hot enough to warp an...
  25. I change every 50 hours with Mobil 1 15w50 and a...

    I change every 50 hours with Mobil 1 15w50 and a good filter not Fram orange.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4