SOLD**sold
Type: Posts; User: washmaster
SOLD**sold
Located in Austin, TX
Good used velvet drive complete with bellhousing, flex plate, cooler, etc. $400
Considering a new (used) boat - probably around an '05 or so. I want to know what is the difference, other than the playpen, between the sunsport and the launch versions of the 22v?
see CL posting:
http://austin.craigslist.org/boa/1689041015.html
I was doing just that when this reply came in. Cleaned polished every connection with dielectric grease. Still trouble so I went back to the Neutral Safety Switch that I initially ruled out when...
okay. Thank you. I assume that breaker is for the starter relay or does it do other things too?
What are the devices to the left of the starter relay? One has a button on it and above that is some type of block.
http://www.geocities.com/continentalthunder/img350.jpg
I ask this because I'm...
glad to see someone from Austin. Was in Lake Austin second wk of march with suit. Wasn't cold at all. Water temp then was 61*. Travis is up to 64* today. I'll be wearing protection "till it...
1:1 tranny, what type of fluid goes in here? Trying to go out tomorrow for the first time this season and noticed level is low. This is an '88 TS6M
-ah
Just pulled my tank out (88 ts6m) to replace the sender. Noticed that there was a ground wire from the fuel filler neck to absolutely nowhere. It seems like it should connect to the tank, right? ...
others have given you pretty much the advise I would have - check the vacuum diaphram on the secondaries in addition to the otherthings mentioned. By way of comparison, my '88 runs out at about...
got a chance to look at my steering cable and rudder.
Cable is definitely too tight. Ordered another one from skidim. The rudder has too much slop also. It swivels just fine, but there's...
I have a similar problem. My steering is tight in both directions, but the rudder has a lot of slop when I wiggle it from under the boat. I thought I'd need just a new steering cable, but after...
Have you checked the timing and firing order?
-ah
push out then turn the arm/knob 90*
Any results on a replacement sender that fits. I also have an '88 with highly eratic guage readings. Its only accurate when totally full.
what should the top speed and corresponding RPMs be for an '88 TS6M with 351?
-ah
got it!
Oops! I guess that would help. '88 TS6M with 351.
-ah
How many degrees advance should the timing be set at? Idle speed?
-ah
Thanks. I got my "generic holley" rebuild kit here locally. It seemed to have all the parts except for the diaphram for the vacuum secondaries. I'll have to go back tomorrow to see if they have...
Does anyone know what the part no. for carb rebuild kit is? I know its a holley carb ('88), but I have no idea which model. The parts stores only know yr/make/model for their computers. No boats...
Okay, thanks. Will have a look-see in tomorrow's daylight. BTW, what size are they? 3" ?
-ag
DK, I like your window decal, but what I need right now it the actual boat decal. This is for a ts6m - 1988. Mine is missing on both sides. Where can I get one in the proper size and configuration...