I know; the Mallory diagram doesn't make sense to me, especially that "all other wires" part that are connected to the (+) of the coil. In our case, that could be seen as the electric choke, and that...
Type: Posts; User: Grover
I know; the Mallory diagram doesn't make sense to me, especially that "all other wires" part that are connected to the (+) of the coil. In our case, that could be seen as the electric choke, and that...
Hey sorry, meant to follow a bit sooner but got distracted. Glad you found the O.E.M. diagram. And very glad you got it sorted out.
Just to confuse things, did you ever run across this Mallory...
The resistor should go into the wire route that leads to the positive side of the coil. There is probably a splice where you removed it from the path, at the back of the engine, off the ignition...
Sounds like chicken soup, it might not help me, but it can't hurt. Certainly one less thing to worry/wonder about.
From what I can tell, the "YL" series Mallory distributors are set up to run modern "high voltage" coils. (internal resistor, no ballast) Now, big disclaimer here, because I'm more familiar with the...
Great responses. Makes perfect sense. Thank you.
I noticed you have a new Mallory ignition. Do you mean the breakerless module? Some of the Mallory ignition modules require a ballast resistor. The older ones sold by Ski D.I.M. did for sure. The...
There are them's that have, and them's that will. Join the club. That damage doesn't look bad at all. I'd say take/send it to good prop shop and have it placed back to perfect, and forgive yourself....
Sent my carb off "to a guy" who had an excellent reputation for rebuilds. I won't go into the particulars, but I got it back, bolted it on, and took it for a shakedown cruise in which it failed...
[QUOTE=michael hunter;105013]Is this what you need?
Thanks for photos. They actually solve the issue. I'm embarrassed to say I didn't realize the ball part of it was in fact the "bushing" that...
Just had carb rebuilt after over a decade of use, ran great until last summer, the spray pattern had gummed up, but that's not the point...
The throttle linkage, where the cable fitting through...
Thanks much. That should get me going again.
Took Holley 4061 carb off to have rebuilt, and it looks like the spacer has never been off. The bolts seem to be fairly corroded going through spacer. I've soaked with
penetrating oil and it's...
I ordered my panels through Island Marine @ (909) 272-9983.
They were recommended by Anthony Cooper at Skier's Choice. Ask for Doug, Kathy, or Ann.
Nice folks.
They are able to get parts from...
Any advice on replacing my instrument panels?
I’ve ordered the panels, and will be swapping out each and every switch, gauge, and instrument.
My thought was to just pull the panel out and start...
Problem solved.
Thanks anyway.
G
I'm not sure what I'm missing here.
My H.I.N. has 16 positions, yet I've learned that there should only be 12. It was licensed this way in Washington State, now in California they've alerted me...
Are they/you talking about the external raw water pick up strainer?
It's just forward of the prop shaft on the left/port side of my hull. It's external through-hull plumming.
Actually, mine is...