Search:

Type: Posts; User: csleaver

Search: Search took 0.01 seconds.

  1. Thread: Vision help

    by csleaver
    Replies
    1
    Views
    926

    I think the vision has a plug that goes to the...

    I think the vision has a plug that goes to the stereo just like the stereo remotes. If it is unplugged somewhere between the stereo and the dash or if there is a problem with the cable or plug it...
  2. Supra with vision use a PDM power distribution...

    Supra with vision use a PDM power distribution module for the ballast and plate. Make sure your power breaker switch is not tripped and maybe unplug the connections and then plug them back in to see...
  3. Replies
    7
    Views
    5,213

    The service required display usually comes up...

    The service required display usually comes up when a sensor is out of range, not when the oil needs to be changed. It is like the check engine light in your car. If the cause of the ecm code is...
  4. Replies
    3
    Views
    1,479

    There should be a harness with a black, yellow...

    There should be a harness with a black, yellow and red wire going to the stereo located in the observer compartment. If you hook a ground wire to the black connector and a 12v positive to the yellow...
  5. Replies
    8
    Views
    2,780

    Try some heat on it. Use a heat gun, not a torch....

    Try some heat on it. Use a heat gun, not a torch. It's like a hair dryer on steroids.
  6. Do you know of a shop or mechanic you can trust? ...

    Do you know of a shop or mechanic you can trust? Perhaps someone that does your annual maintenance, repairs, winterization, or something like that? Have them check it out. If not, ask for a...
  7. Replies
    9
    Views
    2,319

    Are you having an issue with the pre-cat O2...

    Are you having an issue with the pre-cat O2 sensors or the post-cat temp sensors?
  8. Replies
    2
    Views
    2,420

    neutral safety switch

    The neutral safety switch is on the transmission. It may be bad, or the shift cable may be worn or not adjusted properly.
  9. Replies
    6
    Views
    2,716

    Go to the hardware store and get an adjustable...

    Go to the hardware store and get an adjustable wrench for sink drain nuts. They are wide, thin jawed wrenches with a short handle. They sell the same ones at west marine (for about twice as much).
  10. straighten steering wheel

    To find the centered position, drive the boat at cruising speed then place a piece of tape at the 12:00 position. When you are ready to adjust the wheel, turn it back to where the tape is at 12:00,...
  11. fuel filter

    Look in the engine compartment on the starboard side near the vdrive. It should be an inline filter for 1/2 hose.
  12. ballast timer reset

    You may be able to reset the timer by tripping the breaker marked "ballast". It is located in the battery or the engine compartment. Push the button in until the lever pops down, wait a sec then...
  13. Replies
    2
    Views
    1,758

    fuel pump power problem

    It's true that a lot of motors with carbs and electric pumps use an oil pressure safety switch to prevent the fuel pump from running if the motor stalls (they are also wired to the crank circuit to...
  14. Vapor lock issues

    Vapor lock will usually occur during the "heak soak" cycle, between 5 to 90 minutes after shutting off the engine. The best way to avoid vapor lock is to keep the engine compartment cool. Sometimes...
  15. Replies
    6
    Views
    2,422

    Service required display

    What motor do you have. Is it the Assault 8100 or 340 ETX CAT (extreme tuned exhaust with catalitic converters)? The best thing to do is take it the the dealer and see if they can read the trouble...
  16. Replies
    5
    Views
    2,162

    Fuel flow issues

    Many marine fuel tanks have an anti-siphon valve attached between the pickup tube fitting and the fuel line at the tank to comply with coast guard regs. It is a simple one way spring loaded check...
  17. Replies
    11
    Views
    9,984

    Check engine display fix

    You may have a problem with the post cat temp sensors. some 07-08 Indmar 340 Assault/MCX/Monsoon engines with the ETX CAT exhaust and MEFI5B ECM use a sensor in the exhaust down pipe to check the...
Results 1 to 17 of 17