Search:

Type: Posts; User: washmaster

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    11,458

    SOLD**sold

    SOLD**sold
  2. Replies
    2
    Views
    11,458

    Located in Austin, TX

    Located in Austin, TX
  3. Replies
    2
    Views
    11,458

    Velvet Drive 1:1

    Good used velvet drive complete with bellhousing, flex plate, cooler, etc. $400
  4. Replies
    1
    Views
    1,043

    sunsport 22v versus launch 22v

    Considering a new (used) boat - probably around an '05 or so. I want to know what is the difference, other than the playpen, between the sunsport and the launch versions of the 22v?
  5. Replies
    0
    Views
    1,092

    88 comp for sale

    see CL posting:

    http://austin.craigslist.org/boa/1689041015.html
  6. Replies
    4
    Views
    1,991

    I was doing just that when this reply came in. ...

    I was doing just that when this reply came in. Cleaned polished every connection with dielectric grease. Still trouble so I went back to the Neutral Safety Switch that I initially ruled out when...
  7. Replies
    4
    Views
    1,991

    okay. Thank you. I assume that breaker is for...

    okay. Thank you. I assume that breaker is for the starter relay or does it do other things too?
  8. Replies
    4
    Views
    1,991

    intermittant starting problem

    What are the devices to the left of the starter relay? One has a button on it and above that is some type of block.
    http://www.geocities.com/continentalthunder/img350.jpg
    I ask this because I'm...
  9. Thread: Water Temp

    by washmaster
    Replies
    3
    Views
    1,750

    glad to see someone from Austin. Was in Lake...

    glad to see someone from Austin. Was in Lake Austin second wk of march with suit. Wasn't cold at all. Water temp then was 61*. Travis is up to 64* today. I'll be wearing protection "till it...
  10. Replies
    1
    Views
    1,683

    tranny fluid

    1:1 tranny, what type of fluid goes in here? Trying to go out tomorrow for the first time this season and noticed level is low. This is an '88 TS6M
    -ah
  11. Replies
    1
    Views
    1,880

    fuel sender wiring

    Just pulled my tank out (88 ts6m) to replace the sender. Noticed that there was a ground wire from the fuel filler neck to absolutely nowhere. It seems like it should connect to the tank, right? ...
  12. Replies
    18
    Views
    11,899

    top end

    others have given you pretty much the advise I would have - check the vacuum diaphram on the secondaries in addition to the otherthings mentioned. By way of comparison, my '88 runs out at about...
  13. Replies
    9
    Views
    3,862

    more rudder issues

    got a chance to look at my steering cable and rudder.

    Cable is definitely too tight. Ordered another one from skidim. The rudder has too much slop also. It swivels just fine, but there's...
  14. Replies
    9
    Views
    3,862

    I have a similar problem. My steering is tight...

    I have a similar problem. My steering is tight in both directions, but the rudder has a lot of slop when I wiggle it from under the boat. I thought I'd need just a new steering cable, but after...
  15. Replies
    5
    Views
    2,495

    Replying to Topic '86 Supra comp'

    Have you checked the timing and firing order?
    -ah
  16. Replies
    3
    Views
    1,992

    Replying to Topic 'Window Vents'

    push out then turn the arm/knob 90*
  17. Replies
    5
    Views
    3,678

    Replying to Topic 'Fuel Guage Incorrect'

    Any results on a replacement sender that fits. I also have an '88 with highly eratic guage readings. Its only accurate when totally full.
  18. Thread: top speed

    by washmaster
    Replies
    3
    Views
    2,109

    top speed

    what should the top speed and corresponding RPMs be for an '88 TS6M with 351?

    -ah
  19. Thread: carb kit

    by washmaster
    Replies
    5
    Views
    2,308

    Replying to Topic 'carb kit'

    got it!
  20. Replies
    5
    Views
    3,026

    Replying to Topic 'engine timing/ idle speed'

    Oops! I guess that would help. '88 TS6M with 351.

    -ah
  21. Replies
    5
    Views
    3,026

    engine timing/ idle speed

    How many degrees advance should the timing be set at? Idle speed?
    -ah
  22. Thread: carb kit

    by washmaster
    Replies
    5
    Views
    2,308

    Replying to Topic 'carb kit'

    Thanks. I got my "generic holley" rebuild kit here locally. It seemed to have all the parts except for the diaphram for the vacuum secondaries. I'll have to go back tomorrow to see if they have...
  23. Thread: carb kit

    by washmaster
    Replies
    5
    Views
    2,308

    carb kit

    Does anyone know what the part no. for carb rebuild kit is? I know its a holley carb ('88), but I have no idea which model. The parts stores only know yr/make/model for their computers. No boats...
  24. Thread: blowers

    by washmaster
    Replies
    3
    Views
    1,671

    Replying to Topic 'blowers'

    Okay, thanks. Will have a look-see in tomorrow's daylight. BTW, what size are they? 3" ?

    -ag
  25. Replies
    8
    Views
    3,773

    Replying to Topic 'Supra car decal pic...Possible group buy'

    DK, I like your window decal, but what I need right now it the actual boat decal. This is for a ts6m - 1988. Mine is missing on both sides. Where can I get one in the proper size and configuration...
Results 1 to 25 of 27
Page 1 of 2 1 2