Search:

Type: Posts; User: Sluggo

Page 1 of 12 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    35
    Views
    20,286

    Thanks @secondsupra2004, that had crossed my mind...

    Thanks @secondsupra2004, that had crossed my mind as well but wanted to get codes, if any, before buying parts.

    I was able to get my scanner and it did show codes 22 and 34. Low voltage on both...
  2. Replies
    35
    Views
    20,286

    So as it turns out, the coil really appears to be...

    So as it turns out, the coil really appears to be bad, but it did not completely fix the issue. I still have a cold high idle with surging and I think misses as it vibrates more than usual. I just...
  3. Replies
    35
    Views
    20,286

    Just another data point. I found this thread as...

    Just another data point. I found this thread as I was experiencing very similar symptoms. The only difference was that mine did not go away once the engine cooled down. Ran fine for an hour or so...
  4. Replies
    23
    Views
    7,221

    Looks like that is what I am looking at. I...

    Looks like that is what I am looking at. I switched out MAP and TPS back to originals one at a time and there was no difference. Ran it for about 5 minutes and checked the oil. Looked good. Ran...
  5. Replies
    23
    Views
    7,221

    Ok, we have a winner. Apparently my battery that...

    Ok, we have a winner. Apparently my battery that is always on a battery tender did not have enough cranking amps. I combined the two batteries and it fired right up. I immediately noticed there...
  6. Replies
    23
    Views
    7,221

    Ok, more progress today, but no results. Got...

    Ok, more progress today, but no results. Got everything back together and ready to start. Turned key a few times without engaging starter to build up fuel pressure, turned on water, low pressure...
  7. Replies
    23
    Views
    7,221

    More progress today. Removed and re-installed...

    More progress today. Removed and re-installed manifold with new bolts. Everything went fine as I found that 30 ft/lbs was way too much torque. I have found several sources that said 30, but I guess...
  8. Replies
    23
    Views
    7,221

    http://uploads.tapatalk-cdn.com/20161121/376d8b616...

    http://uploads.tapatalk-cdn.com/20161121/376d8b616ffeea428fc4d9b378c9b08e.jpghttp://uploads.tapatalk-cdn.com/20161121/62bc91824de8931b8c0dc3fdcaf1cfe8.jpghttp://uploads.tapatalk-cdn.com/20161121/c4191...
  9. Replies
    23
    Views
    7,221

    I have installed ball valves on the block drains...

    I have installed ball valves on the block drains holes to drain the block. I don't poke anything up in there as I have always had good flow coming out both sides. I would have noticed water that...
  10. Replies
    23
    Views
    7,221

    So if I am at 170-180 psi on all cylinders,...

    So if I am at 170-180 psi on all cylinders, doesn't that tell me my head gaskets, rings, valves are all good? Or relatively good for a 11-12 year old engine with 500 hours? Manual says min is 100...
  11. Replies
    23
    Views
    7,221

    http://uploads.tapatalk-cdn.com/20161102/35553ec80...

    http://uploads.tapatalk-cdn.com/20161102/35553ec8023fe59523140682c74c6d7c.jpghttp://uploads.tapatalk-cdn.com/20161102/d6520c44d69c6f15e1e097d092d20e4a.jpghttp://uploads.tapatalk-cdn.com/20161102/5b637...
  12. Replies
    23
    Views
    7,221

    Ok, so I pulled the intake and exhaust to try and...

    Ok, so I pulled the intake and exhaust to try and find the source of the water intrusion. Here are some picks and the intake gasket looks good to me, almost new if you ask me. I will be replacing...
  13. Replies
    23
    Views
    7,221

    So I was able to get the pressure up to 180 from...

    So I was able to get the pressure up to 180 from 150 after adding some oil. I have never noticed an unusual amount of water in the bilge or any evidence of spraying.

    So my plan at this point is...
  14. Replies
    23
    Views
    7,221

    http://uploads.tapatalk-cdn.com/20161029/a155a85c8...

    http://uploads.tapatalk-cdn.com/20161029/a155a85c8c9bdc1b456d11ea0954bf8f.jpghttp://uploads.tapatalk-cdn.com/20161029/55c566f2e0937666aed2d800eaf207fa.jpg

    Sent from my SM-G935V using Tapatalk
  15. Replies
    23
    Views
    7,221

    2005 22V Rough Idle and Water in Oil!!!

    It has been a while since I have been on here, but did a quick search and did not really find too much about my situation unless this is coincidentally two issues happening at once.

    Boat does not...
  16. Replies
    3
    Views
    1,389

    So I thought about throwing in a bunch of fuel...

    So I thought about throwing in a bunch of fuel injector cleaner, but with a previous vehicle, it took running a couple tanks of gas through it before there were any noticeable results.

    Is that...
  17. Replies
    3
    Views
    1,389

    05 22SSV Fuel Injector Removal

    Have not been on here in a while, but have been searching around and can't find much information on an issue that has me stumped and the boat inoperable.

    Finished a long weekend hboat trip about 4...
  18. Replies
    88
    Views
    61,506

    Computer Information Assurance Engineer. I...

    Computer Information Assurance Engineer. I basically secure computers and networks for various government customers.

    Jasun - I would be interested in the RV equipment testing as well. We have a...
  19. I would be interested, but depends on what you...

    I would be interested, but depends on what you want for them and what shipping might cost. Where are you located?
  20. Replies
    5
    Views
    1,885

    Would my factory 640 (320x2) watt 4 channel...

    Would my factory 640 (320x2) watt 4 channel Kenwood (KAC8401) amp have enough power to run these?
  21. Replies
    26
    Views
    18,105

    In my 05 I had to remove the front and rear...

    In my 05 I had to remove the front and rear carpeted panels and supports, but the 750's fill nicely with that extra room. I don't have a shower though. I also don't use my originals for added...
  22. Replies
    3
    Views
    1,579

    and a Dumpster. lol, j/k. Nice combo. More...

    and a Dumpster. lol, j/k. Nice combo. More pics please! Is that an aluminum trailer?
  23. Replies
    22
    Views
    13,493

    Do you have any pics of the underside or the...

    Do you have any pics of the underside or the install process? Did you get the ladder unit online or locally? If online, could you share the link? What do think your overall cost was to add this? ...
  24. Replies
    6
    Views
    4,996

    Solar flares? I saw on weather.com that they are...

    Solar flares? I saw on weather.com that they are getting ready to publish space related weather! The only other thing I can think of would be if something is obstructing your antenna. I have...
  25. Thread: Co2 poisoning

    by Sluggo
    Replies
    23
    Views
    7,805

    Unless they have ammended this law that went into...

    Unless they have ammended this law that went into effect last July, wake surfing is still legal in Indiana behind an Inboard. Here are a couple articles from Indiana papers when it came out. Not to...
Results 1 to 25 of 293
Page 1 of 12 1 2 3 4